[nguyenhuu]

lg f160 connect ,read write ok,but not format...,config,emmc toshiba
connect lu 6200 ok but not format,not read write

Z3X EasyJtag Software ver. 1.5.6.0
Loading eMMC Addon Firmware... IO: 1850 mV
Box S/N: 0D00401A13836xxx, ,FW Ver.: 01.50
CMD Pullup Level:1680 mV
CMD Active Level:1629 mV
eMMC Device Information
EMMC CID : 90014A48594E49582056001DA162BE7A
EMMC CSD : D04F01320F5903FFFFFFFFEF8A400060
EMMC Manufacturer ID: 0090 , OEM ID: 014A
EMMC Date: 11/2011 Rev.0x56
EMMC NAME: HYNIX , S/N: 1941858
EMMC ROM1 (Main User Data) Capacity: 3448 MB
EMMC ROM2 (Boot Partition 1) Capacity: 2048 kB
EMMC ROM3 (Boot Partition 2) Capacity: 2048 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 2048 kB
Extended CSD rev 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
Backup saved: HYNIX _ 1941858_20140606_1506.extcsd
Done.

Z3X EasyJtag Software ver. 1.5.6.0
Skip loading eMMC Addon Firmware
CMD Pullup Level:1680 mV
CMD Active Level:1639 mV
Reading 0x000000200000 bytes from 0x000000000000 ...ROM2 ( BOOT1 ROM)
Read Check Failed, Reason: CARD Data FIFO Timeout Error
Firmware file...F:\LG\eMMC_Firmware.bin
Running:SAMSUNG: MoviNAND Firmware extraction...

Z3X EasyJtag Software ver. 1.5.6.0
Skip loading eMMC Addon Firmware
CMD Pullup Level:1680 mV
CMD Active Level:1639 mV
ERROR: This eMMC are not Samsung!
Done!