[Dr.Dekra]

z3x easyjtag software ver. 1.9.0.5
loading emmc addon firmware... Io: 2800 mv
box s/n: , ,fw ver.: 01.52
cmd pullup level:2155 mv
cmd active level:2670 mv
emmc device information
emmc cid : 1501003030303030305620110726589c
emmc csd : 902701320f5903fff6dbffef8a404022
emmc manufacturer id: 0015 , oem id: 0100
emmc date: 05/2005 rev.0x56
emmc name: 000000 , s/n: 537986854
emmc name (hex): 30303030303000
emmc rom1 (main user data) capacity: 16384 mb
emmc rom2 (boot partition 1) capacity: 512 kb
emmc rom3 (boot partition 2) capacity: 512 kb
emmc rpmb (replay protected memory block) capacity: 128 kb
emmc permanent write protection: No
emmc temporary write protection: No
extended csd rev 1.5 (mmc 4.41)
boot configuration [partition_config: 0x00] no boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , partition config [179]: 0x00.
Backup saved: 000000_ 537986854_20150303_1018.extcsd
done.

Running:samsung: Emmc firmware update...
Confirmed emmc part number: Kmvtu000lm
z3x easyjtag software ver. 1.9.0.5
loading emmc addon firmware... Io: 2800 mv
box s/n: , ,fw ver.: 01.52
cmd pullup level:2165 mv
cmd active level:2670 mv
setup firmware normal update mode, wait 2..30 sec...
Success!
Sending emmc firmware...
Success!
Verifying emmc firmware...
Success!
Flashing emmc firmware...
Success!
Repairing emmc cid...
Can't init device, reason: Ocr ready timeout error [emmc dead]
done.

what about this error ?