[gorgans]

i need blu studio 5.5 k d710 firmware anyone that have this file please upload.here thanks.
i have d710 stuck on logo i did format but still stuck i read flash from phone and flash phone but still stuck.

================================================== ======
Card found: S/N 0197:0129
Chinese Miracle II [MTK module] v 1.29

Start at : [9/7/2015 / 10:13:36 PM]
Operation : Format FileSystem [ v1.29 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 6 ]
Sync...
Inital regs read done
Boot Info :
BB_CPU_ID : 6571
BB_CPU_HW : CA00
BB_CPU_SW : 8D00
BB_CPU_SB : 0000
BB_CPU_NM : [MediaTek] MT6571_S00
Processing BROM stage
BLVersion : 0x01
SecCfgVal : 0x00000000
BromVersion : 0xFF
BLVersion : 0x01
Preloader Status : Alive
Processing DA stage
DA Select done , sending
DA Ver : MTK_AllInOne_DA_v7.1533.03
NAND_ID : 00000000000000000000000000000000
eMMC_ID : 90014A4834473261110154A39DF8221D
DA Stat : v4.2 on BBID : 0x8B
DA Sent. Configure setting now ...
DA started successuflly
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0090 , OEM : 014A
[eMMC] : FLASH_INF : a2G4
[eMMC] : FLASH_CID : 90014A4834473261110154A39DF8221D
[eMMC] : FLASH_LEN : 0x00000000E9000000
INT RAM : 0x00020000
EXT RAM : 0x20000000
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!


FMT Mode set to : 0
Format : Cache and UserData (Full Factory Reset)

Format CACHE block
Format block Ok!
Format UDA block
Format block Ok!

Done!
Elapsed: 00:00:53
Reconnect Power/Cable!

Finish at : [9/7/2015 / 10:14:29 PM]

========================= Start =========================
9/7/2015 / 10:20:26 PM
================================================== =======
Card found: S/N 0197:0129
Chinese Miracle II [MTK module] v 1.29

Start at : [9/7/2015 / 10:20:56 PM]
Operation : Read Flash [ v1.29 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 6 ]
Sync...
Inital regs read done
Boot Info :
BB_CPU_ID : 6571
BB_CPU_HW : CA00
BB_CPU_SW : 8D00
BB_CPU_SB : 0000
BB_CPU_NM : [MediaTek] MT6571_S00
Processing BROM stage
BLVersion : 0x01
SecCfgVal : 0x00000000
BromVersion : 0xFF
BLVersion : 0x01
Preloader Status : Alive
Processing DA stage
DA Select done , sending
DA Ver : MTK_AllInOne_DA_v7.1533.03
NAND_ID : 00000000000000000000000000000000
eMMC_ID : 90014A4834473261110154A39DF8221D
DA Stat : v4.2 on BBID : 0x8B
DA Sent. Configure setting now ...
DA started successuflly
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0090 , OEM : 014A
[eMMC] : FLASH_INF : a2G4
[eMMC] : FLASH_CID : 90014A4834473261110154A39DF8221D
[eMMC] : FLASH_LEN : 0x00000000E9000000
INT RAM : 0x00020000
EXT RAM : 0x20000000
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!

Reading Flash Conent now ...
USBDL : Init HSUSB Ok!

Brand : BLU
ProdName : BLU STUDIO 5.5 K
ProdModel : BLU STUDIO 5.5 K
Device : BLU
AndroidVer: 4.4.2
MTKxCPU : MT6571
MTKxPRJ : ALPS.KK1.MP7.V1.7

[Read Ok] : preloader_hexing71_cwet_kk.bin
[Read Ok] : MBR
[Read Ok] : EBR1
[Read Ok] : lk.bin
[Read Ok] : boot.img
[Read Ok] : recovery.img
[Read Ok] : secro.img
[Read Ok] : logo.bin
[Read Ok] : system.img
[Read Ok] : cache.img
[Read Ok] : userdata.img

[ScatCFG] : MT6571 / V1.1.1 / hexing71_cwet_kk / EMMC
FW Size : 673 MiB
Scatter saved to : C:\InfinityBox\CM2MTK\Flash\MT6571__BLU__BLU STUDIO 5.5 K__BLU__4.4.2__ALPS.KK1.MP7.V1.7\

All done!

Done!
Elapsed: 00:16:58
Reconnect Power/Cable!