View Single Post
Old 10-05-2015, 03:28   #1 (permalink)
Formingus
Banned
 
Join Date: Jul 2006
Location: dword ptr [ebp-1C], edx
Posts: 4,626
Member: 322417
Status: Offline
Thanks Meter: 940
Donate money to this user
Question Never Repair IMEI on MTK Phones

Where is the problem i cant repair IMEI on MTK Phones

All Ways i am getting same Log
In this case its MTK6589


Phone Info

Quote:
Operation : Check / Read Info [ v1.21 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 19 ]
Sync...
Inital regs read done
Boot Info :
BB_CPU_ID : 6583
BB_CPU_HW : CA01
BB_CPU_SW : 8A00
BB_CPU_SB : 0001
BB_CPU_NM : [MediaTek] MT6583|6589_S00
Processing BROM stage
SecCfgVal : 0x00000000
BromVersion : 0xFF
BLVersion : 0x01
Preloader Status : Alive
Processing DA stage
DA Select done , sending
NAND_ID : 00000000000000000000000000000000
eMMC_ID : 4D0001703430434DD90602475D30A4B8
DA Stat : v3.2 on BBID : 0x86
DA Sent. Configure setting now ...
DA started successuflly
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0070 , OEM : 0100
[eMMC] : FLASH_INF : G40CM
[eMMC] : FLASH_CID : 7001004D4D433034470206D9B8A4305D
[eMMC] : FLASH_LEN : 0x00000000E2C00000
INT RAM : 0x00020000
EXT RAM : 0x40000000
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!

[AP] : Initial info read Ok!

Brand : MTK/6589
ProdName : PhonePadDuo
ProdModel : M-PP2S500
Device : PhonePadDuo
AndroidVer: 4.2.1
MTKxCPU : MT6589
MTKxPRJ : ALPS.JB2.MP.V1.2

Done!
Elapsed: 00:00:22
Reconnect Power/Cable!


IMEI Repair



Quote:
Card found: S/N CB82:0128
Chinese Miracle II [MTK module] v 1.21

Operation : Repair Security [ v1.21 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 19 ]
Sync...
Device boot not done
Check Drivers
Try again

Init Service mode failed, something went wrong

Reconnect Power/Cable!


Operation : Repair Security [ v1.21 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 19 ]
Sync...
Device boot not done
Check Drivers
Try again

Init Service mode failed, something went wrong

Reconnect Power/Cable!


Quote:
Operation : Fix Unknown BaseBand [ v1.21 ]
User accepted FixBB operation!

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 19 ]
Sync...
Inital regs read done
Boot Info :
BB_CPU_ID : 6583
BB_CPU_HW : CA01
BB_CPU_SW : 8A00
BB_CPU_SB : 0001
BB_CPU_NM : [MediaTek] MT6583|6589_S00
Processing BROM stage
SecCfgVal : 0x00000000
BromVersion : 0xFF
BLVersion : 0x01
Preloader Status : Alive
Processing DA stage
DA Select done , sending
NAND_ID : 00000000000000000000000000000000
eMMC_ID : 4D0001703430434DD90602475D30A4B8
DA Stat : v3.2 on BBID : 0x86
DA Sent. Configure setting now ...
DA started successuflly
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0070 , OEM : 0100
[eMMC] : FLASH_INF : G40CM
[eMMC] : FLASH_CID : 7001004D4D433034470206D9B8A4305D
[eMMC] : FLASH_LEN : 0x00000000E2C00000
INT RAM : 0x00020000
EXT RAM : 0x40000000
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!

Step #1
Step #1 ... Ok
Step #2
Step #2 ... Ok
Reset Done!

Done!
Elapsed: 00:00:20
Reconnect Power/Cable!
Thanks

Last edited by Formingus; 10-05-2015 at 03:33.
  Reply With Quote
 
Page generated in 0.08965 seconds with 7 queries