[papinto]

tecno f7
phone condition was hanged on logo
after flashing firmware with sp flash tool, fone now dead
when i read info with my wonderful cm2, this is the error result that i get.
Solution is urgently needed...

chinese miracle ii [mtk module] v 1.43

operation : Check / read info [ v1.43 ]

1. Power off phone , remove battery , insert back
2. Insert usb cable. In some cases require hold bootkey

wait for phone...
Phone found! [ 12 ]
sync...
Inital boot ok!
Bb_cpu_pid : 6583
bb_cpu_nme : [mediatek] mt6583|6589_s00
bb_cpu_ext : 0xca01 , 0x8a00 , 0x0000
processing brom stage
settings for brom configured!
Seccfgval : 0x00000000
bromver : 0x0005
blversion : 0x00fe
preloader : Not active [ erased ]
bootldrss : Normal with spreloader
processing da stage
da select done, will use mtk_allinone_da_v5.1552.01.01
sending and initialize da ...
Running da ver.3.2 on bbid : 0x86
nand flash : Not installed
emmc flash : 204a0190594e49589ca116487790c02f
initialize memory ...

[da_error] : Dram configure failed!
Errocode : 0x2003
emicfg_not_found
try not hold volume(+/-) keys on connect!
Boot error!

Operation failed
elapsed: 00:00:50
reconnect power/cable!