@support
i have a few questions about J700H dead boot repair?
1. iam using the big old ATF metal box with modified pcb! so the adaptor 4in1 ver2 from smartgsm connects in the extension port of the big box right?
2. if the CPU chip is changed (mine is HYNIX) compared to the illustraed ELPIDA the testpoints remain the same? pls see the link below for the EMMC i think its almost the same as the firstpost!
https://drive.google.com/file/d/0B4E...ew?usp=sharing
3. if iam using ATF adaptor Ver 2 from smartgsm do i need any modification to the adaptor pcb?
2. i already have a switch on the for exynos so i dont need to toggle it for connecting this model right?
all this is coz after the testpoint connections, the ATF box cant find the emmc chip always not found!
Quote:
================================================== ====
14:39:51 : ================================================== ====
14:39:51 : eMMC Test Point Connection Module
14:39:51 : ================================================== ====
14:39:51 : ================================================== ====
14:39:51 :
14:39:51 : 1. DO NOT USE THE PHONE"S BATTERY
14:39:51 : 2. Connect the Soldered TP Connections to ATF Box
14:39:51 : 3. Disconnect the USB Cable and Wait until the
14:39:51 : the ATF Software will tell you to Connect the USB.
14:39:51 :
14:39:52 : ERROR: EMMC WAS NOT Detected! 0x01
14:39:52 : Check your Test Point Soldering!
14:42:06 : ================================================== ====
|
pls i need to know what is it iam doing wrong for my connections and to succesfully repair the pcs!
WBR
Atstech