SAMSUNG S6 EDGE+ FRP DONE
FRP REMOVE FAIL
THEN I SOLVE IT WITH THIS SOLUCTION
FIRST
I FLASH THE SBOOT WITH ODIN
<ID:0/014> Added!!
<ID:0/014> Odin engine v(ID:3.1101)..
<ID:0/014> File analysis..
<ID:0/014> SetupConnection..
<ID:0/014> Initialzation..
<ID:0/014> Get PIT for mapping..
<ID:0/014> Firmware update start..
<ID:0/014> SingleDownload.
<ID:0/014> sboot.bin
<ID:0/014> NAND Write Start!!
<ID:0/014> RQT_CLOSE !!
<ID:0/014> RES OK !!
<ID:0/014> Removed!!
<ID:0/014> Remain Port .... 0
<OSM> All threads completed. (succeed 1 / failed 0)
AFTER IS DONE I REMOVE THE FRP WITH Z3X
Operation: Reset FRP/React/EE
Selected model: SM-G928F
Software version: 26.2
Done with Samsung Tool PRO v.26.2
Searching Samsung USB Flash Interface... detected COM14
Setup connection... OK
Reading PIT from phone... OK
Searching FRP lock... OK
Erasing FRP... OK
Searching Reactivation lock... OK
Erasing Reactivation lock... OK
Searching EE lock... OK
Erasing EE lock... OK
Reset done
Done with Samsung Tool PRO v.26.2
THEN WHEN I ON THE PHONE IS HANG ON SAMSUNG LOGO
AND I FLASH IT
Unpacking file... ok
File analysis... OK
Total file size: 0xF3E14C70 (3902 Mb)
Searching USB Flash Interface... detected COM14
Setup connection... OK
Set PIT file... OK
Reading PIT from phone... OK
Sending sboot.bin... OK
Sending param.bin... OK
Sending cm.bin... OK
Sending boot.img... OK
Sending recovery.img... OK
Sending system.img... OK
Sending modem.bin... OK
Sending cache.img... OK
Sending hidden.img... OK
Flashing done (time - 00:03:14)
Done with Samsung Tool PRO v.26.2
AND IS WORK PERFECT NOW
THANKS Z3X