| EMMC CID : 02000053444D30333290FFFFFFFF29BC
EMMC CSD : 8C0F002A015981E9B6D9FC1F8A4040AA
EMMC Manufacturer ID: 0002 , OEM ID: 0000
EMMC Date: 02/2006 Rev.0x90
EMMC NAME: SDM032 , S/N: 4294967295
EMMC NAME (HEX): 53444D30333200
EMMC ROM1 (Main User Data) Capacity: 30 MB
EMMC ROM2 (Boot Partition 1) Capacity: 0 kB
EMMC ROM3 (Boot Partition 2) Capacity: 0 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 0 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.0 (MMC 4.0)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00000000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x00
Device NOT support partitioning feature
Device cannot have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: SDM032_4294967295_20161209_1911.extcsd
Done.
Z3X EasyJtag Software ver. 2.5.0.3
Skip loading eMMC Addon Firmware
CMD Pullup Level:2093 mV
CMD Active Level:2423 mV
Box IO Level:2800 mV
CLK Rate:14000 khz
Reading 0x000000020000 bytes from 0x000000000000 ...ROM1 ( USER ROM)
Output file :C:\Users\student79\Desktop\e330s dump\EMMC_ROM1_SDM032_4294967295_00000000_00020000 .bin
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Read Block Failed, Reason: CARD Data FIFO Timeout Error
Done.
Running:eMMC: Factory Format...
Z3X EasyJtag Software ver. 2.5.0.3
Skip loading eMMC Addon Firmware
CMD Pullup Level:2093 mV
CMD Active Level:2423 mV
Box IO Level:2800 mV
CLK Rate:14000 khz
Formatting eMMC card, please wait up to 3 min...
Setting Service Mode FAILED....
eMMC Format Failed.
Done.
sandisk emmc format failed mr Blang anything wrong from my side? |