Quote:
Originally Posted by fahad javed  EMMC CID : 02000053444D30333290FFFFFFFF29BC
EMMC CSD : 8C0F002A015981E9B6D9FC1F8A4040AA
EMMC Manufacturer ID: 0002 , OEM ID: 0000
EMMC Date: 02/2006 Rev.0x90
EMMC NAME: SDM032 , S/N: 4294967295
EMMC NAME (HEX): 53444D30333200
EMMC ROM1 (Main User Data) Capacity: 30 MB
EMMC ROM2 (Boot Partition 1) Capacity: 0 kB
EMMC ROM3 (Boot Partition 2) Capacity: 0 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 0 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.0 (MMC 4.0)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00000000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x00
Device NOT support partitioning feature
Device cannot have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: SDM032_4294967295_20161209_1911.extcsd
Done.
Z3X EasyJtag Software ver. 2.5.0.3
Skip loading eMMC Addon Firmware
CMD Pullup Level:2093 mV
CMD Active Level:2423 mV
Box IO Level:2800 mV
CLK Rate:14000 khz
Reading 0x000000020000 bytes from 0x000000000000 ...ROM1 ( USER ROM)
Output file :C:\Users\student79\Desktop\e330s dump\EMMC_ROM1_SDM032_4294967295_00000000_00020000 .bin
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Retry reading adress 0x00000000 (Attempt #0)
Retry Fail!
Read Block Failed, Reason: CARD Data FIFO Timeout Error
Done.
Running:eMMC: Factory Format...
Z3X EasyJtag Software ver. 2.5.0.3
Skip loading eMMC Addon Firmware
CMD Pullup Level:2093 mV
CMD Active Level:2423 mV
Box IO Level:2800 mV
CLK Rate:14000 khz
Formatting eMMC card, please wait up to 3 min...
Setting Service Mode FAILED....
eMMC Format Failed.
Done.
sandisk emmc format failed mr Blang anything wrong from my side? |
Hi,
eMMC name SDM032 means not connected VCC or eMMC dead.
Universal Factory format can't repair dead eMMC !
Universal Factory format for eMMC 4.41 and higher revision can only erase ROM1.
Universal Factory format for older eMMC revision (like eMMC 4.2) can erase ROM1, ROM2, ROM3, RPMB and clean WP.
Best Regards