Quote:
Originally Posted by coderinside micromax q372 dead emmc problem then i try to change emmc then try to flash with sp tool error then try to check in cm2 show this error
is it ic is damged or any other problem i also removed volume keys but still same
Operation : Check / Read Info [ v1.58 ]
1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey
Wait for phone...
Phone found! [ 13 ]
Sync...
Inital Boot Ok!
BB_CPU_PID : 6582
BB_CPU_NME : [MediaTek] MT6582_S00
BB_CPU_EXT : 0xCA01 , 0x8A00 , 0x0000
Processing BROM stage
Settings for BROM configured!
SecCfgVal : 0x00000000
BromVer : 0x0005
BLVersion : 0x00FE
PreLoader : NOT Active [ Erased ]
BootLdrSS : NORMAL with PRELOADER
Processing DA stage
DA Select done, will use MTK_AllInOne_DA_v5.1624.16.07
Sending and initialize DA ...
Running DA ver.4.2 on BBID : 0x87
NAND Flash : NOT INSTALLED
eMMC Flash : 65646F4D204D4F521281000002400153
[WARNING] : MEMORY_eMMC_VALIDATE_FAILED
Initialize Memory ...
[DA_ERROR] : DRAM Configure failed!
ErroCode : 0x2003
EMICFG_NOT_FOUND
TRY NOT HOLD VOLUME(+/-) KEYS ON CONNECT!
Boot Error!
Operation Failed
Elapsed: 00:00:36
Reconnect Power/Cable! |
is 2nd emmc?
eMMC Flash : 65646F4D204D4F521281000002400153 because over heat on remove/replease
if CID 0000000000xxxxxxxx
but dram detect bad soldering
if cid detect ram dot detect ram not good soldering
cm2 able detect empty emmc w/o preloader