Unable to activate ADB and remove frp, kindly help where i m wrong? Code:
Operation : Identify [ v1.01 ]
Waiting for device in fastboot mode ...
1. Power off device. Press and hold 'VOL DOWN' button
2. Insert USB cable, hold button until device will be found!
Connect Ok!
Main Info ============
CPU : MSM8952
CID : 0x0032
IMEI : 358223079604290
UID : DB57DB0100000000000000000000
Model Info ============
DevModel : XT1643
IntName : athene_16mp
SW Info ============
DevSWVer : Blur_Version.25.211.8.athene.retail.en.US
DevQCVer : LA.BR.1.3.6-01710-8976.0
BaseBand : M8952_70030.25.03.62.01R ATHENE_INDIA_DSDS_CUST
BootLDRv : moto-msm8952-B1.06
HW Info ============
eMMCInfo : 32GB SAMSUNG RX1BMB RV=08 PV=07 FV=0000000000000007
DRAMInfo : 3GB SAMSUNG LP3 DIE=6Gb M5=01 M6=05 M7=00 M8=7B
Lock Info ============
WarrantyVoid : no
FRP Lock : protected (75)
Done!
Elapsed: 00:00:10
Enable ADB
Code:
Operation : Enable ADB (Moto) [ v1.01 ]
Waiting for NetInterface arrival ...
1. Power off device. Press and hold 'VOL DOWN' and 'POWER ON' buttons
2. Select by 'VOL DOWN' or 'VOL UP' FACTORY MODE , press 'POWER ON'
3. Connect USB cable, when device boot complete!
Connect Ok!
Waiting ...
Trying link with : 192.168.137.2
Connected to device!
Device : XT1643
VerInfo : ATHENE_INDIA_DSDS_CUST
Version : Blur_Version.25.211.8.athene.retail.en.US
Enabling ADB ...
1. Disconnect cable from device, press and hold 'VOLUME_DOWN' and 'POWER_ON'
2. Select 'FACTORY MODE' and press 'POWER ON'!
3. Wait for device boot completely!
Done!
Elapsed: 00:00:09
Operation : Reset FRP (ADB) [ v1.01 ]
Waiting for device in ADB mode ...
1. Connect device, enable 'DEVELOPER MODE' and 'USB DEBUG', if need!
2. Insert USB cable, accept AUTH on PhoneScreen, if software ask!
Device not found! Check cable, drivers and conection!