| Performed by 2.6.1 Software version.
Selected AP file: C:\Users\mohamed abu adam\Desktop\Samsung
\COMBINATION_OXA_FA60_J710FXXU1APD2_OXA1APD2
\COMBINATION_OXA_FA60_J710FXXU1APD2_OXA1APD2
\COMBINATION_OXA_FA60_J710FXXU1APD2_OXA1APD2
_CL7564864_QB9121310_REV03_user_mid_noship.tar.md5
Please put the phone into Download Mode and connect USB cable.
To put SM-J710F into Download Mode, You have to perform the
following steps:
1. Reconnect the battery.
2. Press and hold "Volume-" + "Home" + "Power ON" keys.
3. When phone turns on, press "Volume+" key.
Found phone on
Advanced mode!
Firmware write started.
Writing BOOT section...
BOOT section has been written successfully.
Firmware writing successfully completed.
Performed by 2.6.1 Software version.
-----------------------------------------------------------------------------------
Platform: Samsung Android
Selected port: COM14
Selected model: SM-J710F
Searching for UART interface.. COM5
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...OK
Please connect phone to USB cable..
Searching for a phone. Please wait...OK
Reading data...
Checking operation...OK
Searching for UART interface.. COM5
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Resetting FRP lock (1/4 attempt)..unsuccessful
Searching for UART interface.. COM5
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Resetting FRP lock (2/4 attempt)..success
FRP / Reactivation lock is successfully reseted!
Performed by 2.6.1 Software version. |