Quote:
Originally Posted by -Mosin- Mostly this error belongs wit Hardware faults,like Emmc damaged,or flashed wit wrong preloader. Check Google about Enable Dram fail 4032 error. |
After init preloader device work but scatter is damager not work with CM2 only in SP i use XYZ tool to flash...
Code:
Selected 0-By CPU: MT6580
Scenario: Safe Flash
Reinsert phone battery.
Battery must be charged.
Phone must be off with battery inside.
Please insert USB cable now...
Detected : MediaTek PreLoader USB VCOM Port (COM5)
Phone detected...Please wait
Sending DA agent, please wait...
BaseBand CPU :MT6580_S00
BaseBand CPU Secure Version : FF
BaseBand CPU Bootloader Version : 01
----------------------------------------------------
INT RAM: 128 KB SDRAM
EXT RAM: 768 MB DRAM
----------------------------------------------------
EMMC: (29Gb+6144Mb) SAMSUNG 0x464a32374d42
EMMC FW VERSION: 02:00:00:00:00:00:00:00
EMMC CID: 150100464A3237 : 000000000000000000
EMMC UA SIZE: 0xe9000000
BOOT STYLE: EMMC BOOT
FULL LENGTH: 0xe9880000 [3.649 GB]
Detecting high speed port, wait......
If driver not installed, install high speed port driver.
If not need high speed port, disable it.
After repeat opperation.
Detecting high speed port, wait......
Detected : MediaTek DA USB VCOM Port (COM21)
Warning, flashing preloader disabled!
If you change android version, preloader must be flashed.
Flash EMMC Algo Start.
Starting flash.
Download firmware to flash now...
Wait untill phone will start charging.
but keeps restarting on logo tried factory reset but stiill same