GSM-Forum - View Single Post

love_ofbirds · 12-13-2017, 17:40

the phone is 0p3110 but i not found it in supported odel i found only 0p311200
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.49 (RIFFBOX1), JTAG Manager Version: 1.74
Selected Resurrector: [HTC Desire 500 (0P3Z11200) V1.0.5392.16143]

Connecting to the dead body...OK
Detected dead body ID: 0x008E00E1 - CORRECT!
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0090/0x014A (H4G1D, 0x0000E7000000 Bytes = 3.61 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0090/0x014A (H4G1D, 0x000000200000 Bytes = 2.00 MB)
ERROR: Read Failed with Error Code: 0x28. Terminating at 0x000002E73800

Flashing the dead body...
WARNING: Programming Error (0x25) at 0x000008000200 is handled as Cut Excess.
ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF <> 0x010000)

12-13-2017, 17:40	#1 (permalink)
love_ofbirds Freak Poster Join Date: Sep 2006 Location: TRIPOLI Posts: 121 Member: 342175 Status: Offline Thanks Meter: 5	desair 500 506e the phone is 0p3110 but i not found it in supported odel i found only 0p311200 Open serial port...OK Connecting to the RIFF Box...OK Firmware Version: 1.49 (RIFFBOX1), JTAG Manager Version: 1.74 Selected Resurrector: [HTC Desire 500 (0P3Z11200) V1.0.5392.16143] Connecting to the dead body...OK Detected dead body ID: 0x008E00E1 - CORRECT! Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK Adaptive Clocking RTCK Sampling is: [Sample at MAX] Resurrection sequence started. Establish communication with the phone...OK Initializing internal hardware configuration...OK Uploading resurrector data into memory...OK Starting communication with resurrector...OK Detected an Initialized FLASH1 Chip, ID: 0x0090/0x014A (H4G1D, 0x0000E7000000 Bytes = 3.61 GB) Detected an Initialized FLASH2 Chip, ID: 0x0090/0x014A (H4G1D, 0x000000200000 Bytes = 2.00 MB) ERROR: Read Failed with Error Code: 0x28. Terminating at 0x000002E73800 Flashing the dead body... WARNING: Programming Error (0x25) at 0x000008000200 is handled as Cut Excess. ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF <> 0x010000)