View Single Post
Old 12-29-2017, 05:43   #59 (permalink)
rasgula
No Life Poster
 
rasgula's Avatar
 
Join Date: Feb 2005
Posts: 1,216
Member: 119464
Status: Offline
Thanks Meter: 279
Moto XT1768 Reset FRP successfully done

Moto XT1768 Reset FRP successfully done:

Code:
Platform: MOTOROLA
Selected model: XT1641
Put the phone into Factory Mode: 
1. Power phone OFF; 
2. Press and hold "Vol-" + "Power" buttons; 
3. Select Factory Mode, then confirm your selection; 
4. Wait until the phone Power ON; 
5. Connect USB cable.
Searching for a phone. Please wait...
Phone found.
Reading info...
Phone model: 8937.gen
Firmware released date: May 15 2017
Firmware released time: 23:47:21
Firmware compiled date: May 15 2017
Firmware compiled time: 07:00:00
SW version: MPSS.JO.3.0.c3-00008-8937_GENNS_PACK-1.99093.1.99234.1
Enabling "USB Debugging" mode...
Put the phone in Factory Mode:
1. Disconnect USB cable;
2. Power OFF the phone;
3. Press "Vol-" and "Power" buttons;
4. Select Factory Mode then confirm your selection;
5. Wait until phone is power ON and connect USB Cable;
6. Install necesarry drivers then press "OK" button
Please, press "OK" button on the phone to allow USB debugging..
Searching for a phone (waiting for ADB device)...
Phone found.
Reading info...
Phone model: motorola Moto E (4)
SW version: NPQ26.69-41
Date: Fri Jun  2 23:20:51 CDT 2017
Android version: 7.1.1
Baseband M8917_18.08.04.09R PERRY_NA_CUST
Detected phone model: XT1768
Resetting FRP lock..
FRP lock is successfully reseted!
Performed by 1.0.7 Software version.

Last edited by Octopus box; 12-29-2017 at 08:45.
  Reply With Quote
The Following User Says Thank You to rasgula For This Useful Post:
 
Page generated in 0.11714 seconds with 6 queries