05-22-2018, 14:45
|
#11 (permalink)
|
No Life Poster
Join Date: Jul 2007 Location: Infinity-Box Support-
Posts: 9,321
Member: 541591
Status: Offline
Sonork: 100.1611509 Thanks Meter: 7,361 | Quote:
Originally Posted by kingfaisee Card found : S/N : 583142FE , v0136
Chinese Miracle II [MTK module] v 1.58
Operation : Format FileSystem [ v1.58 ]
1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey
Wait for phone...
Device boot not done
Check Drivers
Try again
Boot Error!
Operation Failed
Elapsed: 00:00:27
Reconnect Power/Cable!
Operation : Format FileSystem [ v1.58 ]
1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey
Wait for phone...
Phone found! [ 14 ]
Sync...
Inital Boot Ok!
BB_CPU_PID : 6580
BB_CPU_NME : [MediaTek] MT6580_S00
BB_CPU_EXT : 0xCA00 , 0x8A00 , 0x0000
Processing BROM stage
Settings for BROM configured!
SecCfgVal : 0x00000000
BromVer : 0x0005
BLVersion : 0x00FE
PreLoader : NOT Active [ Erased ]
BootLdrSS : NORMAL with PRELOADER
Processing DA stage
DA Select done, will use MTK_AllInOne_DA_v5.1624.16.07
Sending and initialize DA ...
Running DA ver.4.2 on BBID : 0x94
NAND Flash : NOT INSTALLED
eMMC Flash : 90014A48384731650507327030494349
Initialize Memory ...
DRAM configured from IDB!
DRAM initialize passed!
DRAM size : 0x40000000
DAgent sent , init HW now
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0x90 , OEM : 014A
[eMMC] : FLASH_INF : [HYNIX] , e1G8
[eMMC] : FLASH_CID : 90014A48384731650507327030494349
[eMMC] : FLASH_BRT : 0x00400000 , 0x00400000 , 0x00400000
[eMMC] : FLASH_LEN : 0x00000001D2000000
[eMMC] : FLASH_UCP : 7456 MiB [eMMC 8 GiB]
DEV RID : 0x206776ECFD654A6CE821E6B568EA5A7D
INT RAM : 0x00020000
EXT RAM : 0x40000000 [1 GiB]
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!
Error read initial info! Make "Identify" first!
Operation Failed
Elapsed: 00:00:20
Reconnect Power/Cable!
i go also on setting >Sp: Other -> NAND init Mode but my problem is not solved | Hello,
And it will keep giving error until you will not follow correct procedure. It was enough to read logs given by software- "Make "Identify" first!"
Just complete Identify first under Service tab and then proceed to Format after successful read info is done.
Br.
Infinity Box Team. |
| |