GSM-Forum - View Single Post - ★★★ Post Here All Successfully Repaired Phones by Ultimate Multi Tool ★★★

akeel2000 · 07-12-2018, 15:43

Device : Xiaomi Redmi Note 5A
Operation : Read Firmware
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM17)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.1.7
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1600500 [8917] 00000000
OPK_DATA : 079E496E26A477B120DFCD85DF7E4AD067164D8292DDD37993 0D5891E3D8240B
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8917.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8917, eMMC, 16 GB
LU Count : 1 [0x01D5A000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
USERDATA : Encrypted
Reading USERDATA will cause large firmware size and slow read speed.
Reading Device Information...OK
Device : Xiaomi Redmi Note 5A [msm8937]
Software : N2G47H, V9.5.8.0.NDFMIFA [Mon May 21 19:48:45 WIB 2018]
Android Ver. : 7.1.2
Patch Level : 2018-04-01
Reading [modem]...Done
Reading [sbl1]...Done
Reading [sbl1bak]...Done
Reading [rpm]...Done
Reading [rpmbak]...Done
Reading [tz]...Done
Reading [tzbak]...Done
Reading [devcfg]...Done
Reading [devcfgbak]...Done
Reading [dsp]...Done
Reading [sec]...Done
Reading [splash]...Done
Reading [aboot]...Done
Reading [abootbak]...Done
Reading [boot]...Done
Reading [recovery]...Done
Reading [system]...Done
Reading [cache]...Done
Reading [persist]...Done
Reading [misc]...Done
Reading [mdtp]...Done
Reading [cmnlib]...Done
Reading [cmnlibbak]...Done
Reading [cmnlib64]...Done
Reading [cmnlib64bak]...Done
Reading [keymaster]...Done
Reading [keymasterbak]...Done
Reading [cust]...Done
Reading [userdata]...Done
Reading [gpt_main0]...Done
Reading [gpt_back0]...Done
Saved to : C:\UMTool\QcFire\Read\Xiaomi_Redmi Note 5A_N2G47H_2018-04-01\
Operation Finished.

07-12-2018, 15:43	#4926 (permalink)
akeel2000 Freak Poster Join Date: Jun 2009 Posts: 392 Member: 1051138 Status: Offline Sonork: 123456 Thanks Meter: 382	Xiaomi Redmi Note 5A read firmare Device : Xiaomi Redmi Note 5A Operation : Read Firmware Checking for existing devices...Not Found Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable. Some phones may need Special Boot Cable or TestPoint for EDL mode. Found Port : Qualcomm HS-USB QDLoader 9008 (COM17) Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.1.7 Connecting to phone...OK Waiting for response...Ignored Init Handshake Sequence...OK Hardware ID : E1600500 [8917] 00000000 OPK_DATA : 079E496E26A477B120DFCD85DF7E4AD067164D8292DDD37993 0D5891E3D8240B Initializing Protocol...OK Using Auto Loader Selection [1] Preparing Firehose Loader...Done Sending Loader [8917.ufl]...Done Executing Loader...OK Detecting Chip Type...OK Hardware : 8917, eMMC, 16 GB LU Count : 1 [0x01D5A000] WARNING! High Speed Driver is not installed. Please install driver from QcFire\Drivers folder using Device Manager. Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512 Reading Partition Table...OK USERDATA : Encrypted Reading USERDATA will cause large firmware size and slow read speed. Reading Device Information...OK Device : Xiaomi Redmi Note 5A [msm8937] Software : N2G47H, V9.5.8.0.NDFMIFA [Mon May 21 19:48:45 WIB 2018] Android Ver. : 7.1.2 Patch Level : 2018-04-01 Reading [modem]...Done Reading [sbl1]...Done Reading [sbl1bak]...Done Reading [rpm]...Done Reading [rpmbak]...Done Reading [tz]...Done Reading [tzbak]...Done Reading [devcfg]...Done Reading [devcfgbak]...Done Reading [dsp]...Done Reading [sec]...Done Reading [splash]...Done Reading [aboot]...Done Reading [abootbak]...Done Reading [boot]...Done Reading [recovery]...Done Reading [system]...Done Reading [cache]...Done Reading [persist]...Done Reading [misc]...Done Reading [mdtp]...Done Reading [cmnlib]...Done Reading [cmnlibbak]...Done Reading [cmnlib64]...Done Reading [cmnlib64bak]...Done Reading [keymaster]...Done Reading [keymasterbak]...Done Reading [cust]...Done Reading [userdata]...Done Reading [gpt_main0]...Done Reading [gpt_back0]...Done Saved to : C:\UMTool\QcFire\Read\Xiaomi_Redmi Note 5A_N2G47H_2018-04-01\ Operation Finished.