View Single Post
Old 07-24-2018, 19:22   #5 (permalink)
serllito
Insane Poster
 
Join Date: Dec 2006
Posts: 69
Member: 415442
Status: Offline
Thanks Meter: 3
flash ok and same problem

Welcome to Octoplus/Octopus Box LG Software version 2.8.7.7
--------------------------------------------------------------------------------
Checking data...OK
Platform: LG MTK
Selected port: COM1
Selected baudrate: 921600
Selected model: SP200
Selected USB connection type
Please, disconnect cable, reconnect battery, connect P999 cable (with
910k resistor)
or
Reconnect battery, press and hold "Vol+" for 10 seconds and connect
Micro USB cable.
Phone found at port COM3011
Mode: Emergency
Initializing flash...OK
Model ID: LM-X210ULMA
Platform: mt6750
Android version: 7.1.2
SW version: SP20010b_00
LAF Version: 1.1
Product ID: VS02S180326003665
IMEI:
Target operator: LAO
Hardware: rev_10
Battery level: 50%
Reading partitions...OK
Checking security...
Checking security passed!
--------------------------------------------------------------------------------
IMEI: 351980-09-659201-7
MEID: 351980-09-659201
Bluetooth address: 48:60:5F:B1:05:1E
Wi-Fi MAC address: 48:60:5F:1D:5C:E3
SPC: 750614
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Writing phone firmware without real necessity is at your own risk.

Downgrade may lead to phone damage!

Please, make sure the phone's battery is fully charged.
Disconnect all other devices from the computer (including phones,
modems, etc.) and close all other running programs.
To avoid errors in the flashing process, use a clean PC (without any
installed drivers for other Qualcomm-based devices).
You should not run any other programs or attach new devices to your
computer during the flashing!
--------------------------------------------------------------------------------
Opening "SP20010b_to_X210ULMA10d_for_unlock.oct"...OK
Setting options...OK
Reading partitions...OK
Formating USERDATA...OK
Formating ENCRYPT...OK
Sending signature...OK
Writing preloader...OK
Writing lk...OK
Writing lk2...OK
Writing laf...OK
Writing boot...OK
Writing recovery...OK
Writing logo...OK
Writing lo_bak_go...OK
Writing secro...OK
Writing tee1...OK
Writing tee2...OK
Writing rct...OK
Writing factory...OK
Writing efuse...OK
Writing md1img...OK
Writing md1dsp...OK
Writing md1arm7...OK
Writing md3img...OK
Writing system...OK
Writing lafbak...OK
Writing ftm...OK
Writing cache...OK
Writing OP...OK
Writing userdata...OK
Formating RCT...OK
Finalizing...OK
Performed by 2.8.7.7 Software version.
only says factory reset in display and reboot
 
The Following User Says Thank You to serllito For This Useful Post:
 
Page generated in 0.08359 seconds with 7 queries