Latest version, same problem.
(Just in case) phone was ok before writing this special firmware.
I just tried to unlock and I'm stuck in that section and I can't even revert it beacuse I can't find Sp200 kdz file.
Tha's the reason I request the file.
Please octoplus team, help me here.
Code:
Welcome to Octoplus/Octopus Box LG Software version 2.8.8
--------------------------------------------------------------------------------
Checking data...OK
Platform: LG MTK
Selected port: COM3
Selected baudrate: 921600
Selected model: SP200
Selected USB connection type
Please, disconnect cable, reconnect battery, connect P999 cable (with 910k resistor)
or
Reconnect battery, press and hold "Vol+" for 10 seconds and connect Micro USB cable.
Phone found at port COM125
Mode: Emergency
Initializing flash...OK
Model ID: LM-X210ULMA
Platform: mt6750
Android version: 7.1.2
SW version: SP20010b_00
LAF Version: 1.1
Product ID: CT66S180208008164
IMEI:
Target operator: LAO
Hardware: rev_10
Battery level: 50%
Reading partitions...OK
Checking security...
Checking security passed!
--------------------------------------------------------------------------------
IMEI: xxxxxxxxxxxxxxxxxxx
MEID: xxxxxxxxxxxxxxxx
Bluetooth address: 00:3D:E8:79:7D:10
Wi-Fi MAC address: 00:3D:E8:EF:12:1D
SPC: 089347
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Writing phone firmware without real necessity is at your own risk.
Downgrade may lead to phone damage!
Please, make sure the phone's battery is fully charged.
Disconnect all other devices from the computer (including phones, modems, etc.) and close all other running programs.
To avoid errors in the flashing process, use a clean PC (without any installed drivers for other Qualcomm-based devices).
You should not run any other programs or attach new devices to your computer during the flashing!
--------------------------------------------------------------------------------
Opening "SP20010b_to_X210ULMA10d_for_unlock.oct"...OK
Setting options...OK
Reading partitions...OK
Formating USERDATA...OK
Formating ENCRYPT...OK
Sending signature...OK
Writing preloader...OK
Writing lk...OK
Writing lk2...OK
Writing laf...OK
Writing boot...OK
Writing recovery...OK
Writing logo...OK
Writing lo_bak_go...OK
Writing secro...OK
Writing tee1...OK
Writing tee2...OK
Writing rct...OK
Writing factory...OK
Writing efuse...OK
Writing md1img...OK
Writing md1dsp...OK
Writing md1arm7...OK
Writing md3img...OK
Writing system...Failed!
Performed by 2.8.8 Software version.
W.B.R.