[ngoclamdt]

Originally Posted by ushe

Opening file: SM-J200H_4-9-2018_19-5-3.pit

Pit: SM-J200H_4-9-2018_19-5-3.pit
Entry count: 31

The size of the last section has been updated

BL_J200HXXU0AOK1_CL874506_QB7051652_REV00_user_low _ship.tar.md5
The list of files in the firmware:
spl.img
sboot.bin
sboot2.bin
param.lfs

Setting frequence to 21 Mhz
CMD Pullup Level: 1691 mV
CMD Active Level: 1742 mV
EMMC Device Information :
EMMC CID: 90014A4838473474210106F50840434E
EMMC CSD: D07F01320F5903FFFFFFFFEF8A400012
EMMC Manufacture : SKHYNIX , EMMC NAME: H8G4t , HEX: 483847347400 , S/N: 06F50840 , rev. 0x01
EMMC Manufacture ID: 0x90 , OEM ID: 0x4A , Device Type: BGA (Discrete embedded) , Date: 4/2016
EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 KB (000000400000)
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01)
Boot configuration [PARTITION_CONFIG]: 0x08 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: H8G4t_06F50840_20190113_211810.extcsd
EMMC Init completed.

Warning: Health report is very BAD

Device Life Time Estimation (MLC) [269]: 0x0B Exceeded its maximum estimated device life time
Device Life Time Estimation (SLC) [268]: 0x01 0% - 10% device life time used
Pre EOL information [267]: 0x03 Urgent

Operation: Write by vendor (Samsung)

Creating GPT-partitioninig
Writing PrimaryGPT at address: 000000000000
Error writing at address: 000000000000 , error: 34 , 34 Unknown error ... Retry #1
Error writing at address: 000000000000 , error: 34 , 34 Unknown error ... Retry #2
Error writing at address: 000000000000 , error: 34 , 34 Unknown error ... Retry #3
Too many errors. Writing has been stopped

HOW TO FIX ......

Repalce EMMC New.good luck
http://forum.gsmhosting.com/vbb/f672...error-2547878/