View Single Post
Old 05-31-2019, 13:09   #837 (permalink)
Akhtar Ali Jatt
No Life Poster
 
Akhtar Ali Jatt's Avatar
 
Join Date: Jan 2009
Location: Sindh Pakistan
Posts: 8,873
Member: 953334
Status: Offline
Sonork: 100.1614005
Thanks Meter: 15,424
Smile Nokia 216

Open VPLfile : RM-1187_059X860_30.01.11.vpl
Description : RM-1187 059X860 IJ 30.01.11
DeviceType : RM-1187
ProductCode : 059X860
SoftwareVer : 30.01.11
PPM LangPack :
[1] : Urdu (Islamic Republic of Pakistan)
[2] : English (United Kingdom)
Load Ok!

Operation : Write FirmWare [ v1.16 ]
Setting : UserData erase : False
Setting : LangPack Only : False

1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...

PTFN : Nokia USB Serial Port (COM20)
MODE : NOKIA USB SERIAL
PORT : 20
BROM : Init BROM
BROM init passed!
CHIP : MT6260 , SBID : 0xCB00 , HWVR : 0x8000 , SWVR : 0x0000
BROM : SECCFG : 0x00000007
BROM : NOKIA USB SERIAL
BROM : 0x05 BL : 0x00
BROM : MEID : 45B108E0D17FCC8704F9272744464B01
BROM : Run BootLoader ...
BOOT : Run BL ver. 01
BOOT : 0x05 BL : 0x01
BOOT : WD : 0005
BOOT : RTC : Setup ...
BOOT : RTC : 000E
BOOT : PRJ : SUEZ.12.00.11.p1
BOOT : SWR : 12.00.11
AGENT : Look for suitable BootChain in DA ...
AGENT : DEFAULT AUTO
AGENT : Found MT6260
AGENT : SUEZ.12.00.11.p1
BOOT : Sending 1st DA ...
BOOT : DA sent
BOOT : Transfer control to DA ...
DA : Sync Passed!
DA : Authentification pass!
DA : Agent : v03.02 on BBID : 0x8B

NOR: 00EF : 0060 : 0018 : 0000
NOR: [WINBOND] W25Q128FW
NOR:
TSIZE : 0x01000000 [ 16.00 MB ]
PSIZE : 0x01000000 [ 16.00 MB ]
STYPE : 0x00000000
FLOTP : DA_NOR_OTP_EXIST

STATUS : OK
BSTYLE : SF_FLASH_BOOT

Boot done!

VPL SoftwareVersion : 30.01.11 [RM-1187]
DEV SoftwareVersion : 12.00.11
SWInfo compare result : DEVICE SW ( Major version ) is LOWER, than in VPL!

Load FlashSet :
MROM : RM-1187_SUEZ_ROM_eMP_30.01.11
LANG : RM-1187_SUEZ_LANG_PACK_ROM_IJ_eMP_30.01.11
CUST : RM-1187_SUEZ_CUSTPACK_ROM_IJ_eMP_30.01.11
JUMP : RM-1187_SUEZ_JUMP_TABLE_IJ_eMP_30.01.11
VIVA : RM-1187_SUEZ_VIVA_eMP_30.01.11

Prepare FlashSet :
DCR : RM-1187_SUEZ_ROM_eMP_30.01.11
DCR : RM-1187_SUEZ_LANG_PACK_ROM_IJ_eMP_30.01.11
DCR : RM-1187_SUEZ_CUSTPACK_ROM_IJ_eMP_30.01.11
DCR : RM-1187_SUEZ_JUMP_TABLE_IJ_eMP_30.01.11
DCR : RM-1187_SUEZ_VIVA_eMP_30.01.11

Prepare Target
SDS : OK : 0x00FF4000 : 0x0000C000

Erase Target Flash
Erase done!

Write Target Flash
Write : RM-1187_SUEZ_ROM_eMP_30.01.11
Write : RM-1187_SUEZ_LANG_PACK_ROM_IJ_eMP_30.01.11
Write : RM-1187_SUEZ_CUSTPACK_ROM_IJ_eMP_30.01.11
Write : RM-1187_SUEZ_JUMP_TABLE_IJ_eMP_30.01.11
Write : RM-1187_SUEZ_VIVA_eMP_30.01.11
Write done, waiting target response ...
Write flash done!

Verify Target FlashContent
Verify : RM-1187_SUEZ_ROM_eMP_30.01.11
Verify : RM-1187_SUEZ_LANG_PACK_ROM_IJ_eMP_30.01.11
Verify : RM-1187_SUEZ_CUSTPACK_ROM_IJ_eMP_30.01.11
Verify : RM-1187_SUEZ_JUMP_TABLE_IJ_eMP_30.01.11
Verify : RM-1187_SUEZ_VIVA_eMP_30.01.11

Done!
Elapsed: 00:02:41
  Reply With Quote
The Following User Says Thank You to Akhtar Ali Jatt For This Useful Post:
 
Page generated in 0.07463 seconds with 7 queries