Code:
Operation : Write FirmWare [ v1.16 ]
Setting : UserData erase : False
Setting : LangPack Only : False
1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...
PTFN : MTK USB Port (COM41)
MODE : NOKIA USB SERIAL
PORT : 41
BROM : Init BROM
BROM init passed!
CHIP : MT6261 , SBID : 0xCB01 , HWVR : 0x8000 , SWVR : 0x0001
BROM : SECCFG : 0x00000007
BROM : NOKIA USB SERIAL
BROM : 0x05 BL : 0x00
BROM : MEID : 05D7299C4C2CA437EB0C48AEEB94B7A1
BROM : Run BootLoader ...
BOOT : Run BL ver. 01
BOOT : 0x05 BL : 0x01
BOOT : WD : 0005
BOOT : RTC : Setup ...
BOOT : RTC : 000E
BOOT : PRJ : KESA61A.11.02.11.p1
BOOT : SWR : 11.02.11
AGENT : Look for suitable BootChain in DA ...
AGENT : DEFAULT AUTO
AGENT : Found MT6261
AGENT : KESA61A.11.02.11.p1
BOOT : Sending 1st DA ...
BOOT : DA sent
BOOT : Transfer control to DA ...
DA : Sync Passed!
DA : Authentification pass!
DA : Agent : v03.02 on BBID : 0x8E
NOR: 00C2 : 0025 : 0037 : 0000
NOR: [MX] MX25U6435E
NOR:
TSIZE : 0x00800000 [ 8.00 MB ]
PSIZE : 0x00800000 [ 8.00 MB ]
STYPE : 0x00000000
FLOTP : DA_NOR_OTP_EXIST
STATUS : OK
BSTYLE : SF_FLASH_BOOT
Boot done!
VPL SoftwareVersion : 11.02.11 [TA-1017]
DEV SoftwareVersion : 11.02.11
SWInfo compare result : SAME
Load FlashSet :
MROM : TA-1017_ROM_eMP_11.02.11
LANG : TA-1017_LANG_PACK_ROM_MD_eMP_11.02.11_001
CUST : TA-1017_CUSTPACK_ROM_MD_eMP_11.02.11_001
JUMP : TA-1017_JUMP_TABLE_MD_eMP_11.02.11_001
VIVA : TA-1017_VIVA_eMP_11.02.11
Prepare FlashSet :
DCR : TA-1017_ROM_eMP_11.02.11
DCR : TA-1017_LANG_PACK_ROM_MD_eMP_11.02.11_001
DCR : TA-1017_CUSTPACK_ROM_MD_eMP_11.02.11_001
DCR : TA-1017_JUMP_TABLE_MD_eMP_11.02.11_001
DCR : TA-1017_VIVA_eMP_11.02.11
Prepare Target
SDS : OK : 0x007F8000 : 0x00008000
Erase Target Flash
Erase done!
Write Target Flash
Write : TA-1017_ROM_eMP_11.02.11
Write : TA-1017_LANG_PACK_ROM_MD_eMP_11.02.11_001
Write : TA-1017_CUSTPACK_ROM_MD_eMP_11.02.11_001
Write : TA-1017_JUMP_TABLE_MD_eMP_11.02.11_001
Write : TA-1017_VIVA_eMP_11.02.11
Flash_Write ERROR : DA_CBR_NOT_FOUND
Error : Flashing failed!
Make sure device HW is in normal condition, check battery and cable!