View Single Post
Old 07-05-2019, 07:30   #865 (permalink)
mbiborna
No Life Poster
 
mbiborna's Avatar
 
Join Date: May 2008
Posts: 2,782
Member: 770503
Status: Offline
Thanks Meter: 1,049
Rm-969 20.14.11.p1 upgrade to ver 30x

Code:
Operation : Write FirmWare [ v1.16 ]
Setting   : UserData erase : True
Setting   : LangPack Only : False

1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...

PTFN : Nokia USB Serial Port (COM54)
MODE : NOKIA USB SERIAL
PORT : 54
BROM : Init BROM
BROM init passed!
     CHIP : MT625A , SBID : 0xCA01 , HWVR : 0x8000 , SWVR : 0x0001
BROM : SECCFG : 0x00000007
BROM : NOKIA USB SERIAL
BROM : 0x05 BL : 0x00
BROM : MEID : B57707CCCC474B5F6AA8D7CF82482E01
BROM : Run BootLoader ... 
BOOT : Run BL ver. 01
BOOT : 0x05 BL : 0x01
BOOT : WD : 0005
BOOT : RTC : Setup ... 
BOOT : RTC : 000E
BOOT : PRJ : Rivendell.20.14.11.p1
BOOT : SWR : 20.14.11
AGENT : Look for suitable BootChain in DA ... 
AGENT : DEFAULT AUTO
AGENT : Found MT625A
AGENT : Rivendell.20.14.11.p1
     BOOT : Sending 1st DA ...
BOOT : DA sent
BOOT : Transfer control to DA ... 
DA : Sync Passed!
DA : Authentification pass!
DA : Agent : v03.02 on BBID : 0x88

        NOR: 00EF : 0060 : 0018 : 0000
        NOR: [WINBOND] W25Q128FW
        NOR: 
              TSIZE  : 0x01000000 [ 16.00 MB ]
              PSIZE  : 0x01000000 [ 16.00 MB ]
              STYPE  : 0x00000000
              FLOTP  : DA_NOR_OTP_EXIST

 STATUS : OK
 BSTYLE : SF_FLASH_BOOT

Boot done!

VPL SoftwareVersion   : 31.01.11 [RM-969]
DEV SoftwareVersion   : 20.14.11
SWInfo compare result : DEVICE SW ( Major version ) is LOWER, than in VPL!

Load FlashSet : 
MROM : RM-969_ROM_eMP_31.01.11
LANG : RM-969_LANG_PACK_ROM_IC_eMP_31.01.11_001
CUST : RM-969_CUSTPACK_ROM_IC_MEA_JO_eMP_31.01.11_001
JUMP : RM-969_JUMP_TABLE_IC_MEA_JO_eMP_31.01.11_001
VIVA : RM-969_VIVA_eMP_31.01.11

Prepare FlashSet : 
DCR : RM-969_ROM_eMP_31.01.11
DCR : RM-969_LANG_PACK_ROM_IC_eMP_31.01.11_001
DCR : RM-969_CUSTPACK_ROM_IC_MEA_JO_eMP_31.01.11_001
DCR : RM-969_JUMP_TABLE_IC_MEA_JO_eMP_31.01.11_001
DCR : RM-969_VIVA_eMP_31.01.11

Prepare Target 
SDS : OK : 0x00FF4000 : 0x0000C000
FFS Format Ok!

Erase Target Flash 
Erase done!

Write Target Flash
Write : RM-969_ROM_eMP_31.01.11
Write : RM-969_LANG_PACK_ROM_IC_eMP_31.01.11_001
Write : RM-969_CUSTPACK_ROM_IC_MEA_JO_eMP_31.01.11_001
Write : RM-969_JUMP_TABLE_IC_MEA_JO_eMP_31.01.11_001
Write : RM-969_VIVA_eMP_31.01.11
Write done, waiting target response ... 
Write flash done!

Verify Target FlashContent
Verify : RM-969_ROM_eMP_31.01.11
Verify : RM-969_LANG_PACK_ROM_IC_eMP_31.01.11_001
Verify : RM-969_CUSTPACK_ROM_IC_MEA_JO_eMP_31.01.11_001
Verify : RM-969_JUMP_TABLE_IC_MEA_JO_eMP_31.01.11_001
Verify : RM-969_VIVA_eMP_31.01.11

Done!
Elapsed: 00:02:51

Reconnect Power/Cable!
  Reply With Quote
The Following 2 Users Say Thank You to mbiborna For This Useful Post:
 
Page generated in 0.14162 seconds with 6 queries