| pleas i have clasic software i dont now setups for repaire can you help me ?
Found 1 serial devices
COM20 USB\VID_0325&PID_0032&REV_0100&MI_00 Easy Jtag Control Port (COM20)
Selected pinout: EasyJTAG GEN1 ISP Pinout
Change EasyJTAG Pinout OK
Z3X EasyJtag Software ver. 3.6.0.0
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 01FFA00C3950E5E7, ,FW Ver.: 01.63
CMD Pullup Level:1815 mV
CMD Active Level:2413 mV
Box IO Level:2800 mV
CLK Rate:7000 kHz
Bus Width:1bit,SDR
HiPower mode is ON!
---------- eMMC Device Information ----------
eMMC CID : 90014A483447326211011F0A02193246
eMMC CSD : D07F01320F5903FFFFFFFFEF8A4040DA
eMMC Manufacturer ID: 0090 , OEM ID: 014A
eMMC Date: 03/2015 Rev.0x1
eMMC NAME: H4G2b , S/N: 520749593
eMMC NAME (HEX): 483447326220
EMMC ROM1 (Main User Data) Capacity: 3728 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 kB
EMMC RPMB is not yet programmed (clear) or RPMB General failure
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.6 (MMC 4.5)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity WP group size [HC_WP_GRP_SIZE: 0x00004000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: H4G2b_ 520749593_20190711_2242.extcsd
Done. |