| After Flashing Set Dead
Welcome to Octoplus/Octopus Box LG Software version 2.9.5
--------------------------------------------------------------------------------
Checking data...OK
Platform: LG Qualcomm
Selected port: COM66
Selected model: LS676
Reading info...
Mode: Emergency
Initializing flash...OK
Platform: msm8909
SW version: LS676ZVC_02
Android version: 6.0.1
LAF Version: 1.1
Product ID: CH31S170822003021
IMEI: 3598***********
Target operator: SPR
Hardware: rev_11
Opening "LS676ZV9_02.tot"...OK
Firmware version: LS676ZV9_02
Firmware model: LGLS676
--------------------------------------------------------------------------------
Writing phone firmware without real necessity is at your own risk.
Downgrade may lead to phone damage!
Please, make sure the phone's battery is fully charged.
Disconnect all other devices from the computer (including phones,
modems, etc.) and close all other running programs.
To avoid errors in the flashing process, use a clean PC (without
any installed drivers for other Qualcomm-based devices).
You should not run any other programs or attach new devices to
your computer during the flashing!
--------------------------------------------------------------------------------
Prepairing firmware...OK
Selecting firmware partitions...OK
Selected default partitions!
Setting options...OK
Do you want to format User Data?
Reading partitions...OK
Formating USERDATA...OK
Formating ENCRYPT...OK
Writing 1/24 PrimaryGPT...OK
Writing 2/24 modem...OK
Writing 3/24 sbl1...OK
Writing 4/24 tz...OK
Writing 5/24 rpm...OK
Writing 6/24 aboot...OK
Writing 7/24 sbl1bak...OK
Writing 8/24 tzbak...OK
Writing 9/24 rpmbak...OK
Writing 10/24 abootbak...OK
Writing 11/24 sec...OK
Writing 13/24 raw_resources...OK
Writing 14/24 raw_resourcesbak...OK
Writing 17/24 persist...OK
Writing 18/24 laf...OK
Writing 19/24 boot...OK
Writing 20/24 recovery...OK
Writing 21/24 recoverybak...OK
Writing 22/24 factory...OK
Writing 23/24 system...OK
Writing 24/24 BackupGPT...OK
Reading partitions...OK
Formating RCT...OK
Formating MPT...OK
Finalizing...OK
Writing firmware done!
Performed by 2.9.5 Software version. |