Quote:
Originally Posted by layder |
Hi Mr Layder
I tried but no sucess
I did type : "Confirm" , But alway got same error.
I need remove EMMC and use socket for this operation ?
Code:
Z3X EasyJtag Software ver. 3.6.1.4
Loading eMMC GEN2 Firmware... IO: 1800 mV
Box S/N: 15AEEBC0126DD0AB, ,FW Ver.: 02.44
CMD Pullup Level:1821 mV
CMD Active Level:1877 mV
Box IO Level:1800 mV
CLK Rate:18000 kHz
Bus Width:1bit,SDR
HiPower mode is ON!
---------- eMMC Device Information ----------
eMMC CID : 90014A484347386134A22986DA722581
eMMC CSD : D02701328F5903FFFFFFFFEF8A400027
eMMC Manufacturer ID: 0090 , OEM ID: 014A
eMMC Date: 02/2018 Rev.0xA2
eMMC NAME: HCG8a4 , S/N: 696703602
eMMC NAME (HEX): 484347386134
EMMC ROM1 (Main User Data) Capacity: 59640 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 kB
EMMC RPMB is programmed and written 1187 times
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.8 (MMC 5.1)
Boot configuration [PARTITION_CONFIG: 0x38] Boot from:ROM1 (Main User Area)
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x38.
H/W reset function [RST_N_FUNCTION]: 0x01
High-capacity WP group size [HC_WP_GRP_SIZE: 0x00004000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: HCG8a4_ 696703602_20191004_2316.extcsd
Done.
Operation not allowed , confirmation password not match!