GSM-Forum - View Single Post - Can't init device, Reason: CARD Ready Timeout Error

sr8787 · 10-24-2019, 14:33

oppo A3s error detect error where is the problem

Found 3 serial devices
COM1 ACPI\PNP0501 Communications Port (COM1)
COM6 USB\VID_0325&PID_0032&REV_0100&MI_00 Easy Jtag Control Port (COM6)
COM83 USB\VID_05C6&PID_9008&REV_0000 Qualcomm HS-USB QDLoader 9008 (COM83)
Selected pinout: EasyJTAG GEN1 ISP Pinout
Change EasyJTAG Pinout OK
Z3X EasyJtag Software ver. 3.6.1.14
Loading eMMC GEN1 Firmware... IO: 3300 mV
Box S/N: 0C0C0321A6B48779, ,FW Ver.: 01.63
CMD Pullup Level:2021 mV
CMD Active Level:2454 mV
Box IO Level:3300 mV
CLK Rate:7000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: CARD Ready Timeout Error
Done.

10-24-2019, 14:33	#1 (permalink)
sr8787 No Life Poster Join Date: Jun 2008 Location: Punjabi University India Posts: 1,473 Member: 788946 Status: Offline Sonork: 100.1682685 Thanks Meter: 502	Can't init device, Reason: CARD Ready Timeout Error oppo A3s error detect error where is the problem Found 3 serial devices COM1 ACPI\PNP0501 Communications Port (COM1) COM6 USB\VID_0325&PID_0032&REV_0100&MI_00 Easy Jtag Control Port (COM6) COM83 USB\VID_05C6&PID_9008&REV_0000 Qualcomm HS-USB QDLoader 9008 (COM83) Selected pinout: EasyJTAG GEN1 ISP Pinout Change EasyJTAG Pinout OK Z3X EasyJtag Software ver. 3.6.1.14 Loading eMMC GEN1 Firmware... IO: 3300 mV Box S/N: 0C0C0321A6B48779, ,FW Ver.: 01.63 CMD Pullup Level:2021 mV CMD Active Level:2454 mV Box IO Level:3300 mV CLK Rate:7000 kHz Bus Width:1bit,SDR HiPower mode is off! Can't init device, Reason: CARD Ready Timeout Error Done.