Quote:
Originally Posted by pintu_das same
Z3X EasyJtag Software ver. 3.6.1.15
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 0900301095CE53A5, ,FW Ver.: 01.63 Warning: CMD Pullup Level , check cables etc.!
CMD Active Level:1815 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is ON!
Can't init device, Reason: CMD Timeout Error
Done. |
wich adaptor u use its low resistor problems
(268 mV) too low