Epik K501 Plus 8.1 FRP Done By CM2SP2 Selected PCD PH4003 GO and connected keeping vol-
Card found : AA747CDA , v0138
Infinity-Box Chinese Miracle II : SPD/USC Module [SP2] v2.03
Load IDBase v10107 Ok!
Operation : Format FS / Reset Settings [ v2.03 ]
Mode : Default [ Reset Settings + FRP ]
BootMode : FLASH
1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!
Wait for device ...
Device Connected!
BootVersion : SPRD3
Boot : INF : PCD : PH4003 GO
Sending Init Boot ...
Boot sent!
Kick FDL ...
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup ...
Port speed : 921600
Sending Flash Boot ...
Boot sent!
Kick FLASH FDL ...
FDL : Control transfered!
Boot Done!
Wipe Ok : UserData
Wipe Ok : Cache
Wipe Ok : FRP
Reconnect Power/Cable!
Done!
Elapsed: 00:00:46 |