[Abul Basher]

nokia 215 hang on logo done

Card found :, v0122
Infinity-Box BEST Nokia [HMD] Module [NK2] v1.20


Open VPLfile : RM1110_059W6Z9_10.01.11.vpl
Description : RM-1110 NDT MEA MS BLACK BENGA BD
DeviceType : RM-1110
ProductCode : 059W6Z9
SoftwareVer : 10.01.11
PPM LangPack :
[1] : Hindi (India)
[2] : English (United Kingdom)
Load Ok!

Operation : Write FirmWare [ v1.20 ]
Setting : UserData erase : True
Setting : LangPack Only : False

1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...

PTFN : Care Suite USB Serial Port (COM43)
MODE : NOKIA USB SERIAL
PORT : 43
BROM : Init BROM
BROM init passed!
CHIP : MT6260 , SBID : 0xCB00 , HWVR : 0x8000 , SWVR : 0x0000
BROM : SECCFG : 0x00000007
BROM : NOKIA USB SERIAL
BROM : 0x05 BL : 0x00
BROM : MEID : CBF04654EAC61D349717E9A6E66B0A5F
BROM : Run BootLoader ...
BOOT : Run BL ver. 01
BOOT : 0x05 BL : 0x01
BOOT : WD : 0005
BOOT : RTC : Setup ...
BOOT : RTC : 000E
BOOT : PRJ : JET.10.01.11.p1
BOOT : SWR : 10.01.11
AGENT : Look for suitable BootChain in DA ...
AGENT : DEFAULT AUTO
AGENT : Found MT6260
AGENT : JET.10.01.11.p1
BOOT : Sending 1st DA ...
BOOT : DA sent
BOOT : Transfer control to DA ...
DA : Sync Passed!
DA : Authentification pass!
DA : Agent : v03.02 on BBID : 0x8B

NOR: 00C2 : 0025 : 0038 : 0000
NOR: [MXIC] MX25U12835FZNI_10G
NOR:
TSIZE : 0x01000000 [ 16.00 MB ]
PSIZE : 0x01000000 [ 16.00 MB ]
STYPE : 0x00000000
FLOTP : DA_NOR_OTP_EXIST

STATUS : OK
BSTYLE : SF_FLASH_BOOT

Boot done!

VPL SoftwareVersion : 10.01.11 [RM-1110]
DEV SoftwareVersion : 10.01.11
SWInfo compare result : SAME

Load FlashSet :
MROM : RM-1110_ROM_eMP_10.01.11
LANG : RM-1110_LANG_PACK_ROM_MS_eMP_10.01.11_001
CUST : RM-1110_CUSTPACK_ROM_MS_MEA_BD_eMP_10.01.11_001
JUMP : RM-1110_JUMP_TABLE_MS_MEA_BD_eMP_10.01.11_001
VIVA : RM-1110_VIVA_eMP_10.01.11

Prepare FlashSet :
DCR : RM-1110_ROM_eMP_10.01.11
DCR : RM-1110_LANG_PACK_ROM_MS_eMP_10.01.11_001
DCR : RM-1110_CUSTPACK_ROM_MS_MEA_BD_eMP_10.01.11_001
DCR : RM-1110_JUMP_TABLE_MS_MEA_BD_eMP_10.01.11_001
DCR : RM-1110_VIVA_eMP_10.01.11

Prepare Target
SDS : OK : 0x00FF4000 : 0x0000C000
FFS Format Ok!

Erase Target Flash
Erase done!

Write Target Flash
Write : RM-1110_ROM_eMP_10.01.11
Write : RM-1110_LANG_PACK_ROM_MS_eMP_10.01.11_001
Write : RM-1110_CUSTPACK_ROM_MS_MEA_BD_eMP_10.01.11_001
Write : RM-1110_JUMP_TABLE_MS_MEA_BD_eMP_10.01.11_001
Write : RM-1110_VIVA_eMP_10.01.11
Write done, waiting target response ...
Write flash done!

Verify Target FlashContent
Verify : RM-1110_ROM_eMP_10.01.11
Verify : RM-1110_LANG_PACK_ROM_MS_eMP_10.01.11_001
Verify : RM-1110_CUSTPACK_ROM_MS_MEA_BD_eMP_10.01.11_001
Verify : RM-1110_JUMP_TABLE_MS_MEA_BD_eMP_10.01.11_001
Verify : RM-1110_VIVA_eMP_10.01.11

Done!
Elapsed: 00:02:57

Reconnect Power/Cable!