GSM-Forum - View Single Post

Burnt Cobba · 12-10-2005, 13:51

hi all

tried this K608i with CID 49. used test point (had some trouble to make test point since it was surrounded with epoxy glue). It was shown that phone colour was RED. (in fact this is silver from 3).. anyway.....

Once cleared the locks , it was asked to repower again... phone then was detected as CID 16. and then test mode was disengaged (according to the log)

Tried to power it up and no power.

Tried to communicate again with phone it reacts ok but stops when sending boot loader.

Is this a hardware or software problem pls? need some guidance asap pls.

thanks for any help
al

12-10-2005, 13:51	#1 (permalink)
Burnt Cobba No Life Poster Join Date: Apr 2002 Location: The Green Mile Posts: 3,653 Member: 11325 Status: Offline Thanks Meter: 266	K608i unlocked ok and then no power... hi all tried this K608i with CID 49. used test point (had some trouble to make test point since it was surrounded with epoxy glue). It was shown that phone colour was RED. (in fact this is silver from 3).. anyway..... Once cleared the locks , it was asked to repower again... phone then was detected as CID 16. and then test mode was disengaged (according to the log) Tried to power it up and no power. Tried to communicate again with phone it reacts ok but stops when sending boot loader. Is this a hardware or software problem pls? need some guidance asap pls. thanks for any help al