| Look at these Stypes if it's wrong plz correct me:
Step N° 1 - INSTALL DIEGO
- Run and install the following file: Diego_3_09.msi
- If you get an error during the installation, it’s because you didn’t uninstall the Nokia connectivity cable driver!
Step N° 2 - INSTALL PHOENIX SERVICE 2004 WITH THE CRACK
- Open the crack first. Just open it, don’t run it now!
- Start installing phoenix 2004. During the installation you’ll get an error message.
- Press on “Retry” and run the crack immediately after! (Check that the destination folder is Windows/system32).
If you’re not fast enough, the message will reappear and you’ll have to re-run the crack the same way as above (but faster…)
- You’ll get 2 error messages, just press OK, and then Finish.
- You successfully installed phoenix service 2004.
Restart your PC.
Step N° 3 - INSTALL PHOENIX 2007
You have the shortcut for Phoenix on your desktop. Run it, and you might get several times the message "dskey not found!”. This is normal, just press « ok », and eventually Phoenix should open.
- Don’t close the program. You must only minimize the window.
- Run phoenix_service_sw_2006_44_6_163.EXE. You shouldn’t have any error!
- Make sure you don’t restart the PC at the end of the installation. Just choose "restart my PC later" and then Finish.
Now you can close the window of Phoenix that you have minimized.
Go to the folder Program files/Nokia/phoenix and copy this entire folder on your desktop.
Restart your PC.
If you have any error messages after the reboot, just press « Cancel ».
Go to /Program files/Nokia/, delete the folder phoenix, then replace it by the folder that you saved on your desktop. Now Re-run the crack of Phoenix 2004.
You can now run Phoenix 2006.
But How to do with Pheonix 2007.
thks |