Quote:
Originally Posted by **** Hi anybody got any idea the best way in which to remove k750i joysticks v3 charging blocks ??? these seem to be fixed to the board via solder which melts only at high temperature.
Jovy system seems good removing plastic parts
(temperature at 185)but Ive took it up a lot higher but still joystick charging blocks do not move. |
1- you have to use lead free flux gel or liquid (it is cheap)
normal flux burn in heat degree lower than solder melting heat degree
keep protective covers in it's module in other side of board
which exposed to lower heater.
2- Use lower heater in re flow (not fast re flow)
3- Use upper heater in fast re flow with adjusting the distance between end
of part and heater 5 cm it is differ between v3 socket and k750i joystick
4- monitor the heat till 220 to 230 not less remove the upper heater and now
all o.k i hope .
if any you welcome to discus
Raheeeeb