6280 v3.81 --> dead --> v6.10. Finally worked! Thought I could share this if someone has similar problems getting the 'Dead phone USB flash' to work:
I started off knowing that I had to do this xtra flash when jumping from 3.81 to 6.10, but was expecting it to be over in a few hours. This was absolutely not the case!
Installed Phoenix 2006_44_6_163 (and Diego 3.09) and used the CA-53 that came with the phone. The flashing seemed to go well for quite a while, until it failed/stopped as expected. Next up, I tried numerous times getting the 'Dead phone USB flash' to work, and spent a lot of hours on it. I also tried upgrading to Phoenix 2007, but still no luck (always using the 'NO CONN.') The result was always 'Failed to send config command to bootcode Error code: 0x84009427' and 'HRESULT 0x84009427'.
The final solution was to install Phoenix 2006_04_6_130 / Diego 3.07 SP2 on another PC! (maybe it could have worked on the 1st one after cleaning and fresh install). Dead phone flashed with 6.10 (using USB cable) straight away! |