Quote:
|
you must read full flash from other hand (ZT303) that good hardware then write to it and after flashing if the phone not working make ask\rpl the phone must be worked if the phone not working after ask\rpl check hardware
|
COM3 [VCP0] selected
Device: Autodetect 6228 NAND
Checking data, wait...
Action: write NAND flash
"format ffs" active
write: Firmware
skip: Customization
skip: Language Pack
skip: Eeprom
protocol ver: 04
ver. sw1: U6_PCB04_GPRS_MT6228_S02.U6V10B015.BIN
ver. sw2: U6V10B015
id-page Ok
nfi area detection finished: Ok
Boot...
Press and HOLD Power button now !
baud autodetection active
19200
Connecting, wait...
Initializing[6228:8A02:8A02]...
chip-id: 0000:0101
boot step size: 0400
Release Power button now !
Boot Done
Initialize...
version: 3.1
NAND: Hynix HY27XS08121M 512+16 32 pages, 66Mb
NAND id: AD76AD76
page size: 200+10
pages/block: 20
bits i/o: 08
address cycles: 04
blocks: 1000
ram size: 00800000
NOR: 0000:000000000000 [00000000]
NAND: 00AD:007600AD0076 [04200000]
warning: NOR flash chip not supported or not detected
Initialize Done
Set baud...
921600
Set baud Done
Identification...
converting data...
done
protocol ver: 04
ver. sw1: U6_PCB04_GPRS_MT6228_S02.U6V10B19.BIN
ver. sw2: U6V10B19
ffs offset/size: 01700000/02900000
id-page Ok
nfi area detection finished: Ok
structure: 2nd [standard] (or higher) generation
Identification Done
Manipulation...
Manipulation Done
Finalization...
Finalization Done
Write...
write core area 1 of 2...
write core area 2 of 2...
formatting...
Write Done
Finished, time used: 296 sec
Remove/Install battery now !
SAME PROBLUM BRO PLS HELP ME