Quote:
Originally Posted by htcode Hi,
I have a JAF Cable and modified it into UFS3 Cable with changing RX2 Cable to VPP.
But MTBOX will not read it even if the Cable is connected to RX2.
What am i doing wrong? What is the right Pinout? I saw in the Sticky the Pinouts but only Picture..
Error
Make sure that phone is connected.
VPP is DISABLED.
BB5 PM back Phone is in: Phone is not responding!
Processing File: rm265__04.80.mcusw
Boot...
FAILED TO BOOT PHONE!!!
Make sure that phone is connected.
VPP is DISABLED.
BB5 PM back Phone is in: Phone is not responding!
Processing File: rm265__04.80.mcusw
Boot...
FAILED TO BOOT PHONE!!!
Regards |
Mate,do you have a 3250 cable???
If your 3250 cable is ready and working, just open your cable or from the battery pins, extend them to your 6500c battery pins.Just remember the BSI and the Negative pin.dont mixed them.
Now observe well, the battery pins from your 3250 cable will be facing the down side of the 6500c.Ajuste the 7 pins of the cable to the seven pins from the phone.Et voila tu es la.
Report.
Tested 4 times so far.
100%