View Single Post
Old 07-01-2008, 07:14   #3 (permalink)
robylp
Junior Member
 
Join Date: Jun 2008
Location: Argentina
Age: 44
Posts: 20
Member: 802887
Status: Offline
Thanks Meter: 6
I have a problem, may be you can help....
I have an IFOE P168+ (CECT P168+) with the MT6225 Chip, dual sim. I have flashing software, imei changer, MTK Format, and so on... Have the USB Standard Cable and one Serial made by me.
The problem is that i made a mistake: I changed PS to USB (instead of UART) and entered a dangerous code: *#6810# that DISABLED THE ENGINEERING MENU and several other codes. The question is:

HOW CAN I CHANGE THE PS TO UART without entering the engineering mode? Is there a way to do that? To change to UART or to revert this bad code so i can use the Engineering menu.

I've reseted the phone, entered all the codes i have found but nothing happened, and searched the forum for two days.
If you could help me i would be very glad, so i continue investigating ways to modify my phone. Thanks in advance.
Regards, Robert.
  Reply With Quote
 
Page generated in 0.12427 seconds with 6 queries