i just recieve one chines phone label w726 made in korea connector pin 1x8 but connector was broken u cant put cable so i remove the all connector and i solder wire and began to find tx and rx and found it
COM1 [Serial0] selected
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection active
Action: reset
Boot...
Press and HOLD Power button now !
baud autodetection active
19200
Connecting, wait...
Initializing[6226:8A02:8A01]...
high speed disabled
boot step size: 0002
Release Power button now !
Boot Done
Initialize...
detecting chip #00 in region #00...
flash: 01227E22202200:2AEA0000000000
flash: Amd AMD/Fujitsu std [D 0004x010000 003Ex040000 0004x010000] 16Mb
number of flash chip/regions detected: 01/01
Initialize Done
Set baud...
115200
Set baud Done
Identification...
device parameters autodetection in progress..
detecting chip #00 in region #00...
flash: 01227E22202200:2AEA0000000000
flash: Amd AMD/Fujitsu std [D 0004x010000 003Ex040000 0004x010000] 16Mb
number of flash chip/regions detected: 01/01
total flash region size: 01000000
detect device identification, method #1...
detection phase #1...
detect device parameters finished
structure: 2nd [standard] (or higher) generation
protocol ver: 04
ver. sw1: M220_PCB01_GPRS_MT6226_S01.K300_1_7.BIN
ver. sw2: K300_1.7
ffs offset/size: 00E00000/00200000
detecting eeprom area in 1 chip(s)...
flash: 01227E22202200:2AEA0000000000
checking area[00000000]: 00000000-00FFFFFF...
eeprom found near: 00E00000
detecting eeprom size...
eeprom size: 00200000
eeprom chip: 00
eeprom area: 00000000:00E00000-00FFFFFF
reading [eeprom[M220_PCB01_GPRS_MT6226_S01.K300_1_7.BIN]]...
file saved: backup_eeprom[M220_PCB01_GPRS_MT6226_S01.K300_1_7.BIN]_20071002-111321.B0E.bin
flash: 01227E22202200:2AEA0000000000
Identification Done
Manipulation...
Manipulation Done
Finalization...
Finalization Done
Write...
formatting...
flash: 01227E22202200:2AEA0000000000
Write Done
Finished, time used: 241 sec
Remove/Install battery now !
thanx to infinty team
