| Hi again?
same thing with SFR231. It still asks for the NP Code after unlock process. Any idea how to get the NP code?
The READ CODE option does not work for me....
COM5 [VCP0] selected
module v2.59
Device: SFR-231
Checking data, wait...
advanced flash detection enabled
Action: "sp-unlock"
unlock method: standard
eeprom backup enabled, it may takes several minutes !
Boot ...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing [6225:8A03:8A00]...
CPU: MT6225
chip: 0001:8403:0002
high speed boot Off
boot packet size: 0400
Release Power button now !
Boot Done
Initialize ...
detecting chip #00 in region #00...
flash: EC257E25082501:2AEA0000000000
flash: Samsung AMD/Fujitsu std [D 0008x002000 00FEx010000 0008x002000] 16Mb
number of flash chip/regions detected: 01/01
Initialize Done
Set baud ...
115200
Set baud Done
Initialize bootcode ...
Initialize bootcode Done
Check firmware integrity ...
detect device identification#1...
detection phase #1...
detect device identification#1 finished
identification#1 structure: 2nd [standard] generation
identification#1 protocol ver: 04
ver. sw 1: ZTENJ25_07A_PMJ_PCB01_GPRS_MT6225_S00.FR_SFR_P109B 2V1_0_3B04.BIN
ver. sw 2: FR_SFR_P109B2V1.0.3B04, 00000000
ffs offset/size: 00B00000/00500000
detect device identification#2...
detection phase #1...
.
detect device identification#2 finished
sim-lock status: unknown
Check firmware integrity Done
Check firmware content ...
Check firmware content Done
Backup required data ...
reading: eeprom[ZTENJ25_07A_PMJ_PCB01_GPRS_MT6225_S00.FR_SFR_P109B 2V1_0_3B04.BIN]...
file saved: C:\Program Files\InfinityBox\MModule\eeprom[ZTENJ25_07A_PMJ_PCB01_GPRS_MT6225_S00.FR_SFR_P109B 2V1_0_3B04.BIN]_20090108-192852.B0E.bin
flash: EC257E25082501:2AEA0000000000
Backup required data Done
Patch required data ...
detection procedure, wait...
detection procedure completed
detection procedure, wait...
detection procedure completed
Patch required data Done
Special operation ...
Special operation Done
Write ...
flash: EC257E25082501:2AEA0000000000
Write: eeprom
Write Done
Finalization ...
Finalization Done
Finished, time used: 748 sec
Remove/Install battery now !
Using the READ CODES method,
COM5 [VCP0] selected
module v2.59
Action: read codes
unlock method: read codes
Model: SFR-231
Checking data, wait...
Phone should be Switched OFF !
Press and HOLD Power button now !
19200 autodetect
error: boot phase #2/1 failed
Can't initialize test mode !
Possible reasons:
1. communication fault, repeat required operation
2. eeprom/ffs serious damaged, use repair eeprom/ffs files or use other unlock/format method
error: operation failed !
Finished, time used: 8 sec
Remove/Install battery now !
Has anyone successfully unlocked this phone using this method? |