LOL its not connecting to MM module coz its CPU type is Qualcom here is result
software version: 1.17
cable type: 1x8 (L8A)
platform: MSM: Qualcomm CDMA, 3G
searching adapter at COM7...
adapter found, version: 2000
pins: 8, plain
power cycles: 1
activation cycles: 5
power-off delay: 20
start Rx/Tx: 1/1
Loading configuration...
Initializing...
Phone should be Powered-On !
Power-On phone now and press "Ok"
Be sure that phone is not in sleep mode during pinout detection !
Press any phone key from time to time to wake-up phone.
detecting pins...
detected baudrate: 115200
result: Rx:1 Tx:2
time required: 1 sec
Power On !
COM7 [VCP1] selected
module v2.74
Device: ZTE-A136G
Checking data, wait...
advanced flash detection enabled
Action: read NOR flash
Boot ...
Press and HOLD Power button now !
error: can't detect device
Release Power button now !
in case of initial connection problem: on/off "Boot baudrate autoselect"
Boot Fail
Finished, time used: 8 sec
Remove/Install battery now !
its connecting Only Pana01Module and QCModule
COM7 [VCP1] selected
module v1.65
Device: ZTE-A136
Checking data, wait...
Action: read eeprom
Boot ...
Press and HOLD Power button now !
e-gold: 820013
loading...
error: can't run preloader: 01
Release Power button now
Boot Failed
Finished, time used: 6 sec
Remove/Install battery now !
COM7 [VCP1] selected
Device: ZTE-201
Checking data, wait...
Action: read information
Connect...
Phone must be Powered-On
Connect Done
Read phone info...
Read phone info Fail
Finished, time used: 12 sec
Remove/Install battery now !
its not unlockable at the moment to any other tool i thnk its CPU type is Qualcom but 2nd Generation
BR
UMER