GSM-Forum - View Single Post

bassemzini · 09-01-2009, 16:35

COM18 [VCP0] selected
module v2.82
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
Action: read ffs/eeprom
Boot ...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing [6225:8A05:8A00]...
CPU: MT6225
high speed boot On
chip: 0001:4303:0005
status: FF
boot packet size: 0400
Release Power button now !
Boot Done
Initialize ...
detecting chip #00 in region #00...
flash: 00E58F7000E58F:00E58F00000000
flash: 20002000200020:00000000000000
number of flash chip/regions detected: 00/01
flash chip is unknown or damaged, operation aborted.
Fault reasons:
1. flash chip is damaged: replace or resolder/reball flash chip
2. hardware is damaged: check hardware, water inside etc.
3. unknown hardware: set "Advanced chip detection method" box [un-checked] and try again
4. wrong model selection, try 'NAND' selection
Initialize Fail
Finished, time used: 15 sec
Remove/Install battery now !

09-01-2009, 16:35	#1 (permalink)
bassemzini Freak Poster Join Date: Jun 2008 Posts: 399 Member: 801936 Status: Offline Thanks Meter: 37	need flash sanno n82y sim2 COM18 [VCP0] selected module v2.82 Device: Autodetect 6205-6227 NOR Checking data, wait... advanced flash detection enabled Action: read ffs/eeprom Boot ... Press and HOLD Power button now ! 19200 fixed Connecting, wait... Initializing [6225:8A05:8A00]... CPU: MT6225 high speed boot On chip: 0001:4303:0005 status: FF boot packet size: 0400 Release Power button now ! Boot Done Initialize ... detecting chip #00 in region #00... flash: 00E58F7000E58F:00E58F00000000 flash: 20002000200020:00000000000000 number of flash chip/regions detected: 00/01 flash chip is unknown or damaged, operation aborted. Fault reasons: 1. flash chip is damaged: replace or resolder/reball flash chip 2. hardware is damaged: check hardware, water inside etc. 3. unknown hardware: set "Advanced chip detection method" box [un-checked] and try again 4. wrong model selection, try 'NAND' selection Initialize Fail Finished, time used: 15 sec Remove/Install battery now !