Quote:
Originally Posted by InfinityHelp  hello!
format it in complete mode and check functionality |
i did format and now phone can boot. i will check functionality and let you know.
COM8 [VCP0] selected
module v2.96
Device: Autodetect 6228-6229 NAND
Checking data, wait...
Action: NAND reset
read mode: 01
Boot ...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing [6228:8A02:8A02]...
CPU: MT6228
high speed boot On
chip: 0031:0000:0101
status: FF
boot packet size: 0400
Release Power button now !
Boot Done
Initialize ...
version: 3.02
cpu-id: 07
loader: 3.0840.00.00
NAND: Hynix HY27XS08121M 512+16 32 pages, 66Mb
NAND id: AD76AD76
page size: 200+10
pages/block: 20
bits i/o: 08
address cycles: 04
blocks: 1000
external ram: 00000000
finalize connection...
done
load emi configuration...
apply emi configuration...
ram size: 02000000
emi configuration done
NOR: 0000:000000000000 [00000000]
NAND: 00AD:007600AD0076 [04200000]
NOR chip is not installed
Initialize Done
Set baud ...
921600
Set baud Done
Identification ...
ram test...
pass 1...
pass 2...
pass 3...
pass 4...
done
reading bootloader structure area (00010000 bytes)...
detecting bootloader structure (chip)...
source data: page only
rom info protocol ver: 04
ver. sw 1: U6_PCB04_GPRS_MT6228_S02.U6V10B015.BIN
ver. sw 2: U6V10B015, 00000000
address offset: 00000000
ffs offset/size: 01700000/02900000
nfi area detection finished: Ok
rom info structure: 2nd [standard] generation
TCL-ID is absent
rom info detection finished
Identification Done
Write ...
formatting...
.................................................. .................................................. Write Done
Finished, time used: 45 sec
Remove/Install battery now !