[blang]

Originally Posted by DUSKnenixs

please i have a problem on flashing this model...
l-------------------------------------------------------------------------------
Selected model: B3310
Selected com port: COM27 <<<USB if you use USB CABLE
Selected speed port: 460800
Decode *.s3 file - please wait
segments 9
segment 1 20300000 30850664 byte
segment 2 2001E000 180 byte
segment 3 20016000 26012 byte
segment 4 20000000 100 byte
segment 5 20078000 1135084 byte
segment 6 2000C000 21504 byte
segment 7 20058000 56 byte
segment 8 20058138 16920 byte
segment 9 2003803C 125176 byte
Phone must be OFF with battery
Please, connect phone and press shortly power button
Syncing phone... OK
Sending loader1... OK
Syncing phone...


always stop on this and no progresss.

1. FLASHING VIA USB CABLE:

- To set the phone to flash mode follow the steps below:

1. Phone off with battery (without the USB cable connected to the phone)
2. Hold the (-) the volume down key + number 9 (nine) for a few seconds and then plug the USB cable to the phone.
3. Release the keys of the volume and number 9

Procedure to write the flash file via USB CABLE:

- Select your phone model eg B 3310
- Select the-------->USB SPEED <---------
- Select the COM port set up after connecting the phone to the PC FLASH MODE eg COM11
- Select the files
- Click on the button FIRMWARE and wait the end.


2. FLASHING VIA RJ45 COM CABLE for DEAD OR ERASED PHONES:

Need make special RJ45 cable with pinouts:

Procedure to write the flash file via RJ45 CABLE:
- Select your phone model eg B 3310
- Select the COM port of RJ45 cable or BOX Port if you using BOX port.
- Select the speed.
- Select the files
- Click on the button FIRMWARE and wait the end.