Action: read/check information
Model: Autodetect 6205-6239 NOR
Checking data, wait...
Phone should be Switched ON !
Connecting, wait...
Phone detected, wait...
Hardware version: MT6235, E04
Hardware version: JRD35_08A_HW
Software version: MAUI.08A.W08.40.SP1.
Software date: 2000.00.00
Barcode: MT012345678901234567
imei-1: 356389032224575
Finished, time used: 2 sec
Remove/Install battery now !
Action: read/check information
Model: Autodetect 6228-6239 NAND
Checking data, wait...
Phone should be Switched ON !
Connecting, wait...
Phone detected, wait...
Hardware version: MT6235, E04
Hardware version: JRD35_08A_HW
Software version: MAUI.08A.W08.40.SP1.
Software date: 2000.00.00
Barcode: MT012345678901234567
imei-1: 356389032224575
Finished, time used: 2 sec
Remove/Install battery now !
COM15 [VCP0] selected
module v3.22
Device: Autodetect 6228-6239 NAND
Checking data, wait...
Action: read/check information
interface: BROM_DLL_v3.1016.00
Connect...
Phone should be Switched OFF !
Press and HOLD Power button now !
bootcode current/expected: 0.0/3.2
CPU: 6235:8A04:8A01
status: 02
bbchip bl ver: FE
NOR flash id[0000]: 0000:000000000000 [AMD] AM29DL323D
chip size: 0Mb
otp status/size: S_DONE/00000000
NAND flash id[0000]: 0000:000000000000 [SAMSUNG] K9F5608Q0C
chip size: 0Mb
page/spare size: 0000/0000
pages per block: 0000
bits i/o: 00
address cycles: 00
internal RAM size: 00000000
external RAM [HW_RAM_UNKNOWN, CS0] size: 00000000
sec error code: AA
error: can not boot device: 1772:S_SECURITY_SLA_INVALID_AUTH_FILE
error: last error: 1772:S_SECURITY_SLA_INVALID_AUTH_FILE
Disconnect...
done
Finished, time used: 9 sec
Remove/Install battery now !
COM15 [VCP0] selected
module v3.22
Device: Autodetect 6205-6239 NOR
Checking data, wait...
advanced flash detection enabled
Action: read/check information
====> Boot ...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing [6235:8A04:8A01]...
CPU: MT6235
high speed boot On
chip: 0000:0000:8003
status: 02
boot packet size: 0400
error: bootcode start error: A4 not authorized: 000000A4
Release Power button now !
Boot Done
====> Initialize ...
detecting chip #00 in region #00...
error: no any expected answer : wrong answer after chip cfi request
number of flash chip/regions detected: 00/01
flash chip is unknown or damaged.
Fault reasons:
1. unknown hardware: contact to support:
[email protected]
2. hardware is damaged: check hardware, water inside etc.
Initialize Fail
Finished, time used: 19 sec
Remove/Install battery now !