GSM-Forum - View Single Post

tomuxzz · 12-14-2010, 14:55

Hello ,the bezel is fine ,because when i put other iphone mainboard the signal is verry good.I think that this item is fault because when i pushed him stronger the signal has became litle bit stronger

.But still no edge and signal strenght is almoust always at 2 .What if i push that component with hot iron ,maby he will stick better with mainboard ? If not i have bad mainboard is it posible to switch it ?

12-14-2010, 14:55	#4 (permalink)
tomuxzz Insane Poster Join Date: Oct 2009 Location: Lithuania Posts: 84 Member: 1147787 Status: Offline Thanks Meter: 12	Hello ,the bezel is fine ,because when i put other iphone mainboard the signal is verry good.I think that this item is fault because when i pushed him stronger the signal has became litle bit stronger .But still no edge and signal strenght is almoust always at 2 .What if i push that component with hot iron ,maby he will stick better with mainboard ? If not i have bad mainboard is it posible to switch it ? Last edited by tomuxzz; 12-14-2010 at 15:04.