View Single Post
Old 02-07-2011, 08:17   #6 (permalink)
Faisal_Computer
No Life Poster
 
Faisal_Computer's Avatar
 
Join Date: Jun 2005
Location: Kamalia, Pakistan.
Age: 38
Posts: 16,852
Member: 151871
Status: Offline
Thanks Meter: 71,425
How to Work On Infinity's B.E.S.T. with Ufs interface on Windows 7 64bit
1.uninstall Ufs drivers if already installed

2. Go to the Start menu and type cmd.exe in the Search Bar. Right click on cmd.exe and choose Run as Administrator



3. If you have the UAC turned on, choose Yes to proceed. Otherwise, you should see the command windows opened already. In the shell window

4. Now in command prompt type these two commands one by one and press enter ( type 1st command then press enter and You’ll get a confirmation that the operation completed successfully then again enter 2nd command You’ll again get a confirmation that the operation completed successfully )

Commands are

Code:
bcdedit.exe -set loadoptions DDISABLE_INTEGRITY_CHECKS
Code:
bcdedit.exe -set TESTSIGNING ON
as you can see below



5.Restart Computer ( it is very important )

6.Install HWK_Support_Suite_Setup_v02.10.000 ( during installing it will ask you to do you want to install new drivers press yes )

7.Plug Ufs with your pc or laptop ( i have laptop ) it will install drivers without any error



8.Open Best -> settings -> connect settings -> select ufs



Now you are ready to use !!
just tested on one Nokia 5800 to test , this one my own mobile so i just test it with boot only i do not want to flash my own mobile

Code:
card found: S/N 1E6E:0116
registered to: Faisal_Computer

Connect phone on selected interface...

UFS S/N 134427 boot - Ok

Connect phone on selected interface...

Read and Check phone data...
Setting FlashMode
FlashMode set Ok

1st boot Ok, C0

CMT part info : 
CMT ASICID   : 000000010000022600010006400C192101031103
CMT EM0 ID  : 00000295
CMT EM1 ID  : 00000B22
CMT PUB ID  : 13000216C97A0052BF22F1B03BC1935A547D241D
CMT MODE ID : 00
CMT R_HASH  : CAEEBB65D3C48E6DC73B49DC5063A2EE
CMT ROM ID  : 4B9B75103E691FF8

CMT : Sending 2nd loader...
Use : RAPIDOv11_2nd.fg
CMT Loader sent, Boot Ok
MCU Configuration
FLASHID : 004000EC , CMT , NAND
CMT Flash ID : 004000EC < SAMSUNG [SEC] => KAT00F00RA [NAND]
FLCNT   : 00030000000000000000000000000000000000
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAPIDOv11_algo.fg
CMT Algo sent
CMT PAPUB : A20187051C30162EE91C77AE5E6011F5F1BA619000
Transmission mode :  Dual (Ddr, TX2) 

Boot Done!


i hope you'll enjoy Infinity's B.E.S.T. with Ufs on Windows Seven 64Bit

Br
Faisal_Computer
  Reply With Quote
The Following 9 Users Say Thank You to Faisal_Computer For This Useful Post:
Show/Hide list of the thanked
 
Page generated in 0.10822 seconds with 7 queries