View Single Post
Old 03-23-2011, 11:19   #71 (permalink)
ranen telecom
Freak Poster
 
Join Date: Mar 2011
Posts: 132
Member: 1536420
Status: Offline
Thanks Meter: 42
write flash file to spd ok

Welcome to use McnBox!
Selected COM21
Baud setting ...
Set Baud done
Initialize in progress ...
Checking data ...
Serial No. MCN*******
Firmware V1.09
Checksum ****-****
Box Connected!
Ready working at COM21
Scanning pin status,please waiting...
->........................
Pin-status Scan Done
Scanning,waiting...
->@@
Operation done, Pin detect out.
BOOTŁ؛2 3 4 5 10 11 12
USB D-: 7 USB D+: 8 Spread
Press [ Save ] to save Pinout
Total expend 1 seconds
...
->#...........
...
Press [ Save ] to save Pinout
[G:1 3 9 11 D-:7 D+:8 Up:2 4 5 10 12] Apply to Box
If Scan other phone, please click [Stop]
[G:1 3 9 11 D-:7 D+:8 Up:2 4 5 10 12] Apply to Box
Checking SCI USB2Serial port, wait...
SCI USB2Serial Port: COM24
Connecting, wait...
Phone Connected!
Info: Spreadtrum Boot Block version 2.0
Initialize boot...
Boot Not support,Please Try other boot.
Checking SCI USB2Serial port, wait...
SCI USB2Serial Port: COM24
Connecting, wait...
Phone Connected!
Info: Spreadtrum Boot Block version 2.0
Initialize boot...
CPU Info 6600L/WT6228
Flash Type NOR
Flash ID 00208810(FFFFFFFF)
Flash Model ST M58WR064ET
Flash Size 0x800000(8.0M)
Start Writing...
Write Done!
  Reply With Quote
The Following User Says Thank You to ranen telecom For This Useful Post:
 
Page generated in 0.13497 seconds with 6 queries