I tried with and without
Gremlin Option ,, and With and Without
Recovery Selection ..
But Phones still on blackscreen. Only two lights comes on bottom keypad.
Code:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.25, JTAG Manager Version: 1.33
Selected Resurrector: [Samsung I9023]
Connecting to the dead body...OK
Detected dead body ID: 0x1BA00477 - CORRECT!
Set I/O Voltage reads as 2.80V, TCK Frequency is 800 kHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip ID: 0x00EC/0x0050 (512MB)
Flashing the dead body...OK
Resurrection complete!
Anything Else I can Try ??? LITTLE MASTER