View Single Post
Old 03-03-2012, 11:22   #6 (permalink)
FasGsm
No Life Poster
 
FasGsm's Avatar
 
Join Date: May 2006
Age: 32
Posts: 1,666
Member: 283725
Status: Offline
Sonork: 100.1584053
Thanks Meter: 1,924
Open SN Write Tool and make sure that the correct COM port is selected and baud rate is set to 115200 bps.

[IMG]http://3.bp.********.com/-nGyjp_vlae4/TVfvcc_79LI/AAAAAAAAAaA/RSPo2cHiofM/s400/Snap14.png[/IMG]

  • While keeping only serial cable connected to the phone, remove the battery and wait 10 seconds with the battery removed.
  • Click Start and you be asked to enter IMEI1 and IMEI2. Enter the correct number in the correct fields.

[IMG]http://1.bp.********.com/-jgz2_PhIuEg/TVfvc1Z4chI/AAAAAAAAAaE/M-JeKJtCINw/s400/Snap15.png[/IMG]

After entering the correct IMEI numbers and clicking OK, you have to replace the battery and press power button on the phone. If you have flashed Android, => Meta mode will appear in the bottom left of the screen.

[IMG]http://1.bp.********.com/-xwLknrwEqAs/TVfvdIoAhVI/AAAAAAAAAaI/pvQf0khUYoY/s400/Snap16.png[/IMG]

Attention: Please follow the instructions carefully. I will not take any responsibility on whatever may happen with your phone.


Update: Here's a trick if you want to flash just one part of the ROM, in this case the recovery. Without formatting flash, deselect all parts except the one you want to flash.

[IMG]http://2.bp.********.com/-s-l8wWxtLOU/ThhIq2fUQEI/AAAAAAAAA_Y/MRLizmDyVTw/s640/Snap6.png[/IMG]


After that, you just have to click start and turn on the phone with USB data cable connected (in this case you don't need the USB serial cable).
  Reply With Quote
The Following 5 Users Say Thank You to FasGsm For This Useful Post:
Show/Hide list of the thanked
 
Page generated in 0.18760 seconds with 6 queries