in lower version of medusa log...
Welcome to Medusa Box Flasher version 1.0.4
--------------------------------------------------------------------------------
Platform: SE Qualcomm
Selected model: MT11i
Prepairing loaders...OK
Please, reconnect battery, attach testpoint and connect USB cable...OK
Sending loader...OK
Waiting for loader...OK
Reading info...OK
Initializing flash...OK
Calculating security...OK
Erasing entire flash...OK
Detected bad blocks: 0
Repairing SBL...OK
Writing TA...OK
Writing TA_MISC...OK
Phone succesfully repaired.
To complete the operation, please write firmware.
problem the same no power...
in latest version of flasher
Welcome to Medusa Box Flasher version 1.0.7
--------------------------------------------------------------------------------
Platform: SE Qualcomm
Selected model: MT11i
Prepairing loaders...OK
Please, reconnect battery, attach testpoint and connect USB cable...OK
Please, disconnect testpoint.
Sending loader...OK
Waiting for loader...OK
Reading info...OK
Initializing flash...OK
Flash type : NAND
Flash ID : 55D1B32C
NAND page size: 2048 b
NAND pages per block: 64 b
NAND spare size: 64 b
NAND blocks count: 8192
Flash size: 1024 MB
Calculating security...OK
Erasing entire flash...OK
Detected bad blocks: 0
Repairing SBL...Failed!
--------------------------------------------------------------------------------
Platform: SE Qualcomm
Selected model: MT11i
Please, reconnect battery, hold "Vol-" key and connect USB cable...Canceled.
--------------------------------------------------------------------------------
Platform: SE Qualcomm
Selected model: MT11i
Prepairing loaders...OK
Please, reconnect battery, attach testpoint and connect USB cable...OK
Please, disconnect testpoint.
Sending loader...OK
Waiting for loader...OK
Reading info...OK
Initializing flash...OK
Flash type : NAND
Flash ID : 55D1B32C
NAND page size: 2048 b
NAND pages per block: 64 b
NAND spare size: 64 b
NAND blocks count: 8192
Flash size: 1024 MB
Calculating security...OK
Erasing entire flash...Failed!
there is failed...
unit is dead...
hope there is a solution on this??? |